Other

TEST CODE COMMENTS
Pass Fail
RESULTSTESTED PROPERTY
MODERN TESTING SERVICES TEST PROTOCOL
SUMMARY OF TEST RESULTS FOR
Shelf / Rack / Cabinet Quality Protocol
REQUIREMENT
H-43012
- - NA
H-43012
X Test load: 55 lbs
H-43012
- - NA
H-43013
- -
Wall-mounting hardware are
provided
ANSI/SOHO
S6.5-01
section 4.2
- -
Wall-mounting hardware are
provided
H-41011
X
No tipping @ 8° inclination for item 30
inches or less in height; OR @ 10°
inclination for item over 30 inches in height.
Apply distributed test loads to all units,
elements, and top surface.
There shall be no structural failure or
permanent deformation greater than ¼
inch.
When Without the claimed capacity
< 8 in Depth (3 lb X Shelf/Top Width)
8 - 16 in Depth (5 lb X Shelf/Top Width)
>16 in Depth (7 lb X Shelf/Top Width)
When the claimed capacity
A) claimed capacity and
B) 1.5 x Claimed Capacity
Report load for each element and total load
on unit for period of 60 minutes, 24 hr for
pegs.
Stability - Incline
Stability Under Vertical Load Test No tip over should occur under the
following conditions
Must not have any one leg lift off the floor
when test load is applied 1 inches from the
edge of 12 inches disk.
Load 125 lb on the disk.
(Report if wall-mounting hardware are
provided and skip the test)
Display Shelf Loading (For light
weight or glass shelves intended
only for display of small or light
items)
Shall withstand distributed loading of 1.5
times claimed capacity or (if no claim
made) 1.5 lb per inch of width, with no
structural failure or permanent deformation
greater than ¼ inch. Report test load used.
No tip-over should occur under the
following conditions
Horizontal force of 40 lb or an angle > up to
10 deg before tipping occur. Force is
applied through an 8 inches disk 54 inches
above floor or 4 inches below the top,
whichever is lower
(Report if wall-mounting hardware are
provided and skip the test)
Loading capacity - top surface Less than 1000 mm: 165 lbs
1000 mm or above: 55 lbs
No damage with the load evenly distributed
on the top surface for 1/2 hours
Furniture - stability - for unit over 42
inches height
Distributed Load Test
(Not applicable for glass shelf.)
Page 3 of 6