INSTRUCTION MANUAL 3PCS Cast Aluminum Bistro Set
· Only need to rinse it thoroughly with clean water to wash away dirt and grime. Never use abrasive cleansers on the furniture, since it can attack the surfaces and leave behind scratch marks. · For the stubborn grime and stains, just use a soft sponge and mild soapy water and then dry it with a cloth or paper towel. INTRODUCTION · Check the stability of the screws, nuts and nut caps prior to each use. If necessary, tighten all of them again to ensure it is secure.
Part Number ASSEMBLY INSTRUCTIONS Images and Sizes Qty. Stud M8*35 D E F DEFG M8 Flat washer M8 Spring washer 3 3 G M6*30 Stud 4. Attach the right and left arm(E,F) using the bolts (G) and washers ,nuts (H,I,J) .DO NOT over tighten .And then using bolts (K) and washers and nuts (H,I,J). Adjust to a correct place , then tighten G&K.Add the protect hats (O). 3 M8 Nuts 1. Place all parts on a clean soft surface. 2.
Part Number ASSEMBLY INSTRUCTIONS G H I J K 3. Attach the leg support (C) to the table legs (B) using bolts (H),washers and nuts (I,J,K). L Images and Sizes M6*30 Stud 4 M6 Flat washer M6 Spring washer M6 Nuts M6*25 Stud 12 12 12 8 M8 Flat washer 20 M8 Spring washer M 1.Place all parts on a clean soft surface. Qty. M8 Nuts N 20 20 M6 protect hats 12 O P 4.Tighten all the nuts using the wrench .
