Assembly & Installation Instructions

ManualsBrandsCharlton Home ManualsCeiling LightsVan Reipen 1 - Light Single Bell Pendant

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box

Mounting Strap (A)

Green Grounding

Screw (E)

Fixture Mounting

Screw(D)

Mounting Screw (B)

Wire Nut (C)

Installation Steps

Lock Nut (F)

Upper Rod

Middle Rod

Lower Rod

Fixture body

Socket

Glass Shade

Socket ring

Bulb

Bulb Type A Max.100W

(not included)

Spacer

Ball Nut (G)

Threaded Pipe

Fixture Canopy

Ball Nut (G)

Outlet Box

House Grounding Wire

Wire Nut(C)

Fixture Mounting Screw (D)

Mounting Strap(A)

Green Grounding Screw(E)

Lock Nut(F)

Mounting Screw(B)

1. Attach two fixture mounting screws to the mounting

strap, and then secure it with two lock nuts. Adjust

the length of the fixture mounting screws if necessary.

2. Attach the mounting strap to the outlet box using two

mounting screws.

. Rod Connections:

a. Thread the fixture wire from the fixture through the

lower rod, and then secure the lower rod onto fixture

using the threaded pipe.

b. Thread the fixture wire through the middle rod, and then

secure the middle rod onto the lower rod using the

threaded pipe.

c. Thread the fixture wire through the upper rod, and then secure the

upper rod onto the middle rod using the threaded pipe.

d. Thread the fixture wire through the fixture canopy, and then secure

the fixture canopy onto the upper rod using the threaded pipe.

Note: Length adjustable from 19-1/4" to 64-1/4". Use

fewer rods if shorter length is desired.

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
4. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows: ---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source. ---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source. ---Attach the fixture grounding wire to the mounting strap with the green grounding screw, and then connect it to the house grounding wire with a wire nut. Carefully put the wires back into the outlet box.