Installation & Assembly

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT
OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.
Installation Steps
Ceiling Box
House Grounding Wire
Grounding Wire
Wire Nut
Screw
Mounting Strap
Grounding Screw
Lock Nut
Mounting Screw
Canopy
Bolt Nut
Upper Tube
Middle Tube
Down Tube
Fixture Wire
Glass Shade
Socket Ring
Nipple
Nipple
1.Insert 2 screws to the mounting strap, and secure
with the lock nuts.
2.Attach the mounting strap to ceiling box by using 2
mounting screws.
3.Tube connections:
a.Thread the fixture wire from the socket through
the down tube(w/o nipple), and then secure down
tube with the nipple into the cap.
b.Thread the fixture wire from the assembled tube
through the middle tube(w/ niple) and secure the
middle tube with the nipple.
c.Thread the fixture wire through the upper tube(w/ nipple),
and then secure the upper tube with the nipple.
*The height can be adjustable to 16-3/8", 26" or 35-5/8"
by using the tubes.
4.Thread the fixture wire through the canopy, and attach
the upper tube to the canopy with the set-nipple.
5.Make wire connections with wire nuts:
---The black wire from fixture to the black wire
from power source.
---The white wire from fixture to the white wire
from power source.
---Attach the grounding wire and house grounding wire
to the mounting strap with a green grounding screw.
Carefully tuck wires back into the ceiling box.
6.Attach the canopy to the mounting strap by inserting
the screws, and secure with the 2 bolt nuts.
7.Attach the glass shade to the cap, and secure with
the socket ring.
8.Install a bulb.(Please do not exceed the
maximum capacity, which is recommended
on the socket)
9.Turn on the power at fuse or circuit box.
Set Nipple
Cap
Nipple