Installation & Assembly
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation
instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
A
TTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1).
*Shut
off the power at the circuit breaker and remove old fixture, including
the
old small hard
w
are.
1.
Carefully unpack your new fixture and lay out all the parts on a clear area. Be
careful and don’t lose any small parts that’s necessary for installation. The
finial
(Part
A) is hided inside the top cover (Part B) for packaging purposes.
2.
Install the light bulbs(not included) in accordance with the fixture specific
ations.
NOTE
: DO NOT EXCEED THE SPECIFIED WATTAGE!
3.
Raise the pipe nipple of the finial(A) insert cover (B) and lock it securely with
the
hex nut(D).
4.
Attach the cover(B) onto the fixture body(E), aligning the holes on it and lock
it
s
ecurely with hex nut(C). Screw the pole(F),(G) together tightly. Follow wiring
instructions carefully (see fig.2).
5.
Put the pole(I) onto the concrete base using the mounting kn
ob(J).
A.
The depth of the base will depend on local soil conditions and
f
rost line. The diameter of the base should be 305mm in order
to hold the anchor bolts on the plate.
B.
Take the three bolts(L) and run a hex nut(M) fully down each part of t
he
thread
ed section. Insert the bolt(L) to the template(K) and secure with t
he
se
cond hex nuts.
C.
Mix and pour the concrete into the former until it reaches the top. Push the
assembly into concrete until the plate are 0.25inches above the
concrete .Leaving 2.5 inches of the thread above the conc
rete.
D. It is
important to level the template before the concrete sets.
7.
Install the fixture together with the pole(F),(G) onto the pole(I),secure them using
the machine screws(H).
CONNECTING THE WIRES (Fig.2)
*Feed the fixture wires through the pole(F),(G) .
1.
Take the black wire(hot) from the outlet box and the black wire of fixture and t
wist
bare e
nds together. Twist wire connector onto end of wire until snug.
2. Repeat same process with white wire(neutral) from outlet box and white wire of
fixture.
NOTE: Twist wires together in the same direction you twist the wire
connector onto wires.
3.
If your outlet box has a grounding wire (green or bare copper), attach this wire and
the bare copper wire from the fixture together as step 1.If junction box has
no
grou
nd wire, attach the bare copper fixture wire to the green ground screw in the
bottom of the pole(I)
.
4.
Tuck the wire connections neatly into the pole. Take the fixture(E) mount onto
the
pole(F).
Y
our installation is now complete. Return power to the junction box and test the
fixture.
Fig.1
FIXTURE
WIRES
Black
or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White
or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
Fig.2