Installation Guide
1of 2
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
(2)B10CandelabraBasebulbs60WMaximum,bulbnotincluded.
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.MissingParts?Contactyouroriginalplaceof
purchase.
LightSource:
EstimatedAssemblyTime:
Preparation:
ToolsRequired: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Installation Guide
Package Contents
Fixture Body
x1
B
Crossbar Assembly
x1
A
Figure 2
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
STEP 2 - Wire Connections
A.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Glass
x2
C
STEP 1 - Install the Crossbar Assembly to Outlet Box and Adjust
the length of the Nipple
A. Attach the Crossbar Assembly (A) to the Outlet Box with the head of
the Green Ground Screw facing you. Secure it with Outlet Box
Screws (not included), tighten until snug
B. Adjust the hex nut and lock washer underside of the crossbar to the
middle of the nipple.
C. Remove the from the Nipple. Place the Backplate of the
Fixture Body (B) over the Nipple against the wall to determine the
correct position of the nipple. Thread the Finial onto the Nipple.
Adjust the nipple to allow the Backplate the Fixture Body (B) to rest
against the wall when held in place by the .
D. Remove the and the Fixture Body (B). Tighten the lock
washer and the hex nut against the crossbar to secure in place.
.
Lock Ball
Lock Ball
Lock Ball
Outlet Box Screw
(not included)
Hex Nut and
Lock Washer
Outlet Box
Green Ground Screw
A
Lock Ball
Figure 1
Nipple
Backplate
Outlet Box
STEP 3 Install Fixture Body-
A. Carefully tuck all wires into the outlet
box and position the backplate of the
Fixture Body (B) over the outlet box.
Attach the backplate of the Fixture
Body (B) over the Nipple (BB) and
secure with the Lock ball. Hand
tighten until snug.
Figure 3
Backplate
A
Lock Ball
STEP 4 Install the Glass and the Bulb-
A. Place the Glass (C) over the candle cover.
B. Insert the bulb onto the socket and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Bulb (not included)
C
candle cover
Figure 4
Pleasegoto our website for product cleaning tips.Go to the
Care + Maintenance
selection.