User's Manual

--------------------------------------------------------------------------------------------------------------------- CDC-1 User Manual
39
How to edit P2 program
① Press P2 button 3 times, the screen displays “Programming PGM2”
② Select one chart then press right side button of ◀PROGRAM▶ to save.
③ Select the next chart then save it in the same way with ②
④ By repeating above, save charts want to use
⑤ Finally press P2 button to exit program edit.
How to use P2 program
① Press P2 butotn one time. It will show the chart first saved.
② To see the 2nd saved chart, press the right side button of ◀PROGRAM▶
③ Each time press right button of ◀PROGRAM▶, the next chart appears.
Left side button of ◀PROGRAM▶ displays the previous chart.
④ During running the program, you can press any other chart that is not saved in the program. To return and
continue the program, just press the right side button of ◀PROGRAM▶
8.3.3. Set Remote Controller IR Channel
Once you change IR channel in configuration menu, the remote controller used just before doesn’t work anymore. It
is because IR channel of the device and remote controller are not match. In this case, have to change IR channel of
remote controller to the same channel of the device.
When change IR channel of remote controller, it is convenient to change the channel in IR channel menu. For details,
refer IR Channel section of this manual.
If you are not in IR channel menu, it is impossible to check which IR channel the remote controller is in. In this case
press any key after changing the channel of remote controller. When the device reacts to the remote signal, then it
means both channels are matched.