Specifications

Chassis Plans CPR-30201 Technical Reference
Page 8
Sleep Mode
The display will enter sleep mode (turn off) if there is no input signal to the selected input mode. The delay to enter
Sleep Mode when the signal is not valid is approximately 6 seconds. When in sleep mode, the Power LED will
flash green. Pressing the Power button or Source button will exit the Sleep Mode and the display will scan the
selected input port for a signal. If no signal is present, the display will once again enter Sleep Mode. Note that
having a signal present on another port will not prevent the display from going into Sleep Mode if no signal is
present on the selected port. The display will only scan the selected port and does not auto-scroll through the other
ports.
Note that you can bring up the OSD menu when the display is brought out of Sleep Mode port but the OSD will
disappear when the display again enters Sleep Mode after not finding a signal.
Entering Sleep Mode will disable the PIP and revert to a TV PIP default. Use the front panel PIP to select the PIP
source and size to again display the PIP window. Alternatively, use the OSD to enable PIP.