Installation Guide

Corbel Collection
Installation Instructions:
!!
TOOL & MATERIAL
CHECKLIST
Pencil
Drill / screwdriver
Screws (provided)
Safety glasses!
IMPORTANT INFO
• The screws provided are for mounting to a solid surface, if
mounting to other surfaces (i.e. drywall) you will need to
purchase additional hardware, longer screws for studs or
drywall anchors.!
• When a corbel is used in a load bearing application (i.e.
granite or stone), each corbel can support up to 110 lbs each.
!
•
Silicon adhesive or construction adhesive can be used on top
of corbel to add additional contact surface.!
1.
2.
3.
INSTALL INSTRUCTIONS:
1. Determine the location you wish to install.
Remove bracket from corbel by removing
six screws, three on each side. Hold the
plate against the wall, (Tip: Place two
pennies on top of bracket as a spacing
guide.) and mark the holes with a pencil. If
the corbel is going to be used for
countertop support or to display a heavy
item, make sure the plate is secured to a
stud.
2. Drill pilot holes into the marks on the wall
and attach the plate with the four provided
screws. If you plan on installing the corbel
into drywall, you will need to purchase
drywall anchors and screws.
3. Snap the decorative face of the corbel onto
the plate. Screw the six screws into the
side of the corbel to secure it into place.
!
EXAMPLE DIAGRAM:!
Installation video available at www.jka-home.com