Remote Infrastructure Management RIM-600 User Manual

RIM-600 Manual

Enterprise Status

Unit Type IP Status

RIM-600 Monitor Host 10.1.4.10 Ok

NY_Node Node 10.1.4.17 Ok

Press any key to return to main menu

Option 2 will display the network configuration for the Host as well as web server, RAS, and two-

way email settings. A sample of Option 2 is shown below:

Network and Option Configuration

Physical Address 00:D0:C9:37:40:86

IP Address 10.1.4.10

Subnet Mask 255.255.255.0

Default Gateway 10.1.4.1

DNS Server 10.1.2.111

Enterprise name RIM-600 Enterprise

Web Server Enabled

Web Server Security Enabled

Web Programming Option Enabled

Web Programming Security Enabled

Remote Access Server Enabled

RAS IP Port Address 0.0.0.0

Two-Way E-mail Responder Enabled

Microphone Listen-in Enabled

Datamodem Enabled

SNMP RO community public

SNMP RW community private

SNMP Agent Enabled

Allow remote configuration Disabled

Press any key to return to main menu

Option 3 will allow you to set all pertinent network settings listed under Option 2.

NOTE: You can remotely reconfigure the Host network settings using the

RIM-600

ConsoleView software if the Allow Remote Configuration option is set to Y. However, the Host

must initially be configured via the serial port before any remote configuration is possible.

Option 4 allows you to configure or reconfigure the Enterprise name.

Option 5 allows you to configure the Web server. When Web security is enabled, a Profile

Username & Password must be entered to view the web page. A sample of the Web configuration

menu is shown below:

Configure Web Server

1. Enable Web Server: Y/N

2. Enable Web Status Security: Y/N

3. Enable Web Programming option: Y/N

4. Enable Web Programming Security: Y/N