Remote Infrastructure Management RIM-600 User Manual

RIM-600 Manual
2828
Option B allows you to change the Local Configuration password.
Option C allows you to reset all settings to their default values.
Option D will display statistics.
Option E will save all changes and reboot the system. A reboot is required for changes to take
effect.
Option F will save all changes and logout, but the changes will not be activated until the system
reboots.
Local Configuration Definitions
Password: This is the password which protects access to the local configuration parameters.
The default password in a new unit is “rim600.”
IP: This is the IP address assigned to the RIM-600 on your network. This address is provided by
you or your network administrator. It is formatted as a standard dotted decimal number.
Mask: This is the subnet mask which distinguishes the portion of the IP address that is the
network ID from the portion that is the station ID.
Gateway: A TCP/IP network must have a gateway to communicate beyond the LAN identified
by the network ID. A gateway is a computer or router that is connected to two different
networks and can move TCP/IP data from one to the other. If your TCP/IP network has more
than one LAN or if you are connecting to the Internet, you will need to know the IP address
of the gateway that will transfer TCP/IP data in and out of your LAN. A single LAN that is
not connected to other LANs does not require a gateway setting.
DNS: The DNS server is used to translate site names into actual numeric network addresses.
Enter the IP address of the DNS server for your network.
Enable Web: Setting this to “
Y” will enable the web page feature of the RIM-600. Set this to
"N" if you do not want the unit to produce a web page.
Enable Web Password: Setting this to “
Y” will require a valid user-name and password to be
entered in order to view the web page.
Enable RAS: Setting this to “
Y” will enable Remote Network Access during a dial-up
connection.
RAS IP: This is the IP address assigned to the remote computer calling in to the host.
Enable 2-Way E-mail: Setting this to “
Y” will enable the 2-way email feature. With this
feature enabled you can send commands to the RIM-600 via e-mail and receive responses
back. Set this to "
N" to disable this feature.
Enterprise Name: The Enterprise name will appear at the top level of the
RIM-600
ConsoleView software whenever a user logs in to an RIM-600 Host. It provides identification
consistency among multiple users and allows for future Enterprise features.
Enable Microphone Listen-In: Enabling this feature will allow users to listen in through the
microphone on the front panel of the unit when dialing the unit in Voice mode. Disabling this
feature will prevent the microphone from being accessed during a telephone call.