Remote Infrastructure Management RIM-600 User Manual

RIM-600 Manual
34
Battery Replacement
The RIM-600 Node uses one (1) 6V 3.4AH rechargeable battery (included) for backup power in
the event that main power fails. The unit will constantly recharge the battery whenever the power
switch is turned on and the unit is plugged into a power supply.
In the event you need to replace the battery, contact technical support for part number information.
To install the new battery, first slide the power switch to the OFF position and disconnect the power
adapter. Next, remove the top cover of the unit by removing the six screws using a small flat-head
screwdriver. Remove the wire connectors from the old battery and replace it with the new one.
Reconnect the wires to the new battery and reattach the top cover.
Figure 8: Battery replacement in the Node unit
Rack Mount Installation
The RIM-600 Node can be rack mounted using the included rack mount brackets. Follow the steps
below:
1) Attach rack-mount brackets to the Node with a Phillips screwdriver.
2) Attach the unit to the equipment rack using two pan-head screws per side. Tighten the
screws with a Phillips screwdriver.
3) Plug the power adapter into a power outlet.
Figure 9: Rack-mounted Node Unit
Wall Mount Installation
The RIM-600 Node can be wall mounted using the optional wall mount brackets. Follow the steps
below:
1) Attach the optional wall mount brackets to the sides of the
RIM-600 using the eight black #6-
32 screws. A Phillips screwdriver will be required. (Order part # 60075-001 Universal Wall
Mount Kit)
2) Attach the unit to the wall using two screws per side. Tighten the screws with a Phillips
screwdriver.
3) Plug the power cord into a 120VAC 60Hz outlet.