Remote Infrastructure Management RIM-600 User Manual

RIM-600 Manual
64
Figure 32: Class Selection screen
Deleting a Profile
From the hierarchy on the ConsoleView screen, right-click on the profile you wish to delete and
select Delete This Profile in the contextual menu.
Contacts
The Contacts are the actual telephone numbers, e-mail addresses, pager numbers, etc… that the
RIM-600 will contact when an alarm occurs. You can have up to 8 Contacts per User Profile.
Each Contact can have its own Schedule so that you can have certain Contacts be Enabled during
daytime hours and others Enabled during nighttime hours. Only Contacts which are Enabled when
the alarm occurs, will be contacted.
The order of Contacts can be changed at any time. To move a Contact up or down in the list, click
and hold the Contact you wish to move and drag it to its new location, then release the mouse
button. The Contact should now display in its new location.
Adding Contacts
To add a Contact, right-click on the User Profile you wish to add a contact to and select Add New
Contact. An entry called New Contact will appear below the User Profile. Right-click on the New
Contact and select Setup. The following screen will appear:
Figure 33: Contact Setup Screen
Enter a Name which describes the contact, like “Jim’s Cell,” “Acme Inc. Fax,” or “Jim at home.”
Select the Contact Type using the drop down arrow. The choices are: Voice, Numeric Pager, Alpha
Pager, Fax, Email, and SNMP.
Destination: Enter the Telephone Number, E-mail Address, or Server Name/Address for the contact.
64