User Guide

Page 8 of 15 BOB LED User Manual Rev. 5
3. SETUP
AC Power
The BOB LED has a fixed power supply and it can work with an input voltage of 120 VAC,
60 Hz or 230 VAC, 50Hz. To determine the product’s power requirements (
circuit breaker,
power outlet, and wiring), use the current value listed on the label affixed to the product’s
back panel, or refer to the product
’s specifications chart. The listed current rating indicates
the product’s average current draw under normal conditions.
• Always connect the product to a protected circuit (circui
t breaker or
fuse). Make sure the product
has an appropriate electrical ground to
avoid the risk of electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods
of non-use completely disconnect the product from power via br
eaker
or by unplugging it.
Never connect the product
to a rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer channel serves only as a 0 to 100%
switch.
Fuse
Replacement
1. Disconnect the product from power.
2. With a Phillip's head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse.
4. Replace with a fuse of the same type and rating.
5. Screw the fuse holder cap back in place and reconnect power.
Disconnect the product from the power outlet before replacing the fuse.
Fuse Holder
Power Cord In