User Manual
GEYSER T6 TABLE OF CONTENTS 1. Before You Begin ....................................................................... What Is Included ........................................................................................... Unpacking Instructions.................................................................................. Claims ............................................................................................................................ Text Conventions ...........................
BEFORE YOU BEGIN 1. BEFORE YOU BEGIN What Is Included • • • Geyser T6 Power Cord FCM Remote • • Warranty Card Quick Reference Guide Unpacking Instructions Carefully unpack the product immediately and check the container to make sure all the parts are in the package and are in good condition. Claims If the box or the contents (the product and included accessories) appear damaged from shipping, or show signs of mishandling, notify the carrier immediately, not Chauvet.
BEFORE YOU BEGIN Safety Notes • • • • • • • • • • • • • • • • • • • • • • • • • • Not intended for permanent installations. Always connect the product to a grounded circuit to avoid the risk of electrocution. Always disconnect this product from the power source before cleaning it or replacing the fuse. Make sure the power cord is not crimped or damaged. Never disconnect the power cord by pulling or tugging on the cord. Do not mount this product on a flammable surface (e.g.
INTRODUCTION 2. INTRODUCTION Product Overview Tri LEDs Output Nozzle Carry Handle Fan Fluid Tank Fluid Level Indicator LED Display Manual Button Menu Buttons Controller In Power In Rubber Feet for Surface Mounting (x4) Fuse Holder Product Dimensions 7 in 178 mm 12 in 305 mm Geyser T6 User Manual Rev. 1 8.
SETUP 3. SETUP AC Power The Geyser T6 has a fixed voltage power supply and it can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific model. To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. The listed current rating indicates the product’s average current draw under normal conditions.
OPERATION 4. OPERATION Control Panel Operation To access the control panel functions, use the four buttons located underneath the display, and the two manual control knobs located to the right of the display. Please refer to the Product Overview to see the button and knob locations on the control panel.
OPERATION Configuration After connecting power, allow 1.5 to 2 minutes for the Geyser T6 to heat up before triggering fog output. Manual Configuration To select which color or program the Geyser T6 will output when the manual button is pressed on the back panel of the product or the included FC-M remote, follow the instructions below. 1. Press
MAINTENANCE AND STORAGE 5. MAINTENANCE AND STORAGE Fog Machine Maintenance Do not allow the fog machine to become clogged. After every 40 hours of continuous operation, use CHAUVET Fog Cleaner Quart (FCQ) through the system to prevent the accumulation of particulate matter in the heating element. The recommended cleaning procedure is as follows. 1. Unplug the product from power. 2. Empty all fog fluid from the machine. 3. Add cleaning solution to the tank. 4.
TECHNICAL SPECIFICATIONS 6. TECHNICAL SPECIFICATIONS Dimensions and Weight Length 12 in (305 mm) Width 8.25 in (210 mm) Height 7 in (178 mm) Note: Dimensions in inches rounded to the nearest decimal digit. Power Power Supply Type Range Model-specific 120 VAC, 60 Hz, or 230 VAC, 50 Hz Weight 7 lb (3.2 kg) Voltage Selection Fixed Parameter Consumption Operating Current Fuse 120 V, 60 Hz 830 W 6.9 A F 12 A, 250 V 230 V, 50 Hz 830 W 3.
RETURNS RETURNS In case you need to get support or return a product: • If you are located in the U.S., contact Chauvet World Headquarters. • If you are located in the UK or Ireland, contact Chauvet Europe Ltd. • If you are located in Mexico, contact Chauvet Mexico. • If you are located in Benelux, contact Chauvet Europe BVBA. • If you are located in any other country, DO NOT contact Chauvet. Instead, contact your local distributor. See www.chauvetdj.com for distributors outside the U.S.
CONTACT US CONTACT US World Headquarters General Information Technical Support Address: 5200 NW 108th Ave. Voice: (844) 393-7575 Sunrise, FL 33351 Fax: (954) 756-8015 Voice: (954) 577-4455 Email: chauvetcs@chauvetlighting.com Fax: (954) 929-5560 Toll Free: (800) 762-1084 Website www.chauvetlighting.com EUROPE General Information Technical Support Address: Stokstraat 18 9770 Kruishoutem Belgium Email: eutech@chauvetlighting.eu Website www.chauvetlighting.
