User Manual

Page 4 of 10
SETUP
Geyser T6 User Manual Rev. 1
3. SETUP
AC Power
The Geyser T6 has a fixed voltage power supply and it can work with an input voltage of either 120 VAC,
60 Hz or 230 VAC, 50 Hz, depending on the specific model.
To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart.
The listed current rating indicates the product’s average current draw under normal conditions.
Fuse Replacement
1. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
2. Pry the fuse holder out of the housing.
3. Remove the blown fuse from the holder and replace with a fuse of the exact same type and rating.
4. Insert the fuse holder back in place and reconnect power.
• Always connect the product to a protected circuit (a circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by
unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
Disconnect the product from the power outlet before replacing the fuse.
While operating the Geyser T6, make sure there is adequate haze fluid in the
machine to prevent pump and heater damage. When the haze fluid level becomes
low, simply add more haze fluid to continue using the Geyser T6.
This product may NOT be tilted. This product should be level when on a surface.
Safety cap
Spare fuse holder
(inside safety cap)
Installed fuse
(held by plastic clip)