Manualshelf

User Manual

ManualsBrandsCHAUVET DJ ManualsFog MachinesCHAUVET DJ Geyser T6 GEYSERT6
12345678910
Page 6 of 10
OPERATION
Geyser T6 User Manual Rev. 1
Configuration
Manual Configuration
To select which color or program the Geyser T6 will output when the manual button is pressed on the back
panel of the product or the included FC-M remote, follow the instructions below.
1. Press <MENU> repeatedly until CoLo shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select a color or program, from P 0 (no color), P 1 (static red), P 2
(static green), P 3 (static green), P 4 (static yellow), P 5 (static magenta), P 6 (static cyan), P 7
(static white), P 8 (strobing red), P 9 (strobing green), P 10 (strobing blue), P 11 (strobing yellow),
P 12 (strobing magenta), P 13 (strobing cyan), P 14 (strobing white), P 15 (color snap program),
or P 16 (color fade program).
4. Press <ENTER>.
Optional Wireless Remote (FC-W)
The optional FC-W wireless remote (not included) allows up to 4 preset colors or programs to be triggered
from up to 100 ft (30 m) away, through the built-in receiver in the Geyser T6.
To configure which color or program gets triggered by which button on the FC-W (<1>–<4>), do the
following:
1. Press <MENU> repeatedly until CH-1 (<1>), CH-2 (<2>), CH-3 (<3>), or CH-4 (<4>) shows on
the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select a color or program, from P 0 (no color), P 1 (static red), P 2
(static green), P 3 (static green), P 4 (static yellow), P 5 (static magenta), P 6 (static cyan), P 7
(static white), P 8 (strobing red), P 9 (strobing green), P 10 (strobing blue), P 11 (strobing yellow),
P 12 (strobing magenta), P 13 (strobing cyan), P 14 (strobing white), P 15 (color fade program),
or P 16 (color snap program).
1. Press <ENTER>.
2. Repeat until all 4 channels are configured as desired.
FC-W Wireless Remote Overview
Temperature
To view the current temperature of the heater, press <MENU> repeatedly until Ht shows on the display,
then press <ENTER>.
After connecting power, allow 1.5 to 2 minutes for the Geyser T6 to heat up before
triggering fog output.
Ensure the FC-W remote has an unobstructed view of the product for maximum
performance.