User Manual
TABLE OF CONTENTS 1. Before You Begin .......................................................................................................... 3 What Is Included ............................................................................................................................. 3 Unpacking Instructions .................................................................................................................... 3 Claims........................................................................
1. BEFORE YOU BEGIN What Is Included Unpacking Instructions Claims Text Conventions • • • • Gobo Zoom USB Power Cord Warranty Card Quick Reference Guide Carefully unpack the product immediately and check the container to make sure all the parts are in the package and are in good condition. If the box or the contents (the product and included accessories) appear damaged from shipping, or show signs of mishandling, notify the carrier immediately, not Chauvet.
Product at a Glance Use on Dimmer Outdoor Use Sound-Active DMX Master/Slave Safety Notes x x x P P Auto Programs Auto-ranging Power Supply Replaceable Fuse User-Serviceable x P P x Please read the following Safety Notes carefully before working with the product. The Notes include important safety information about installation, usage, and maintenance. • • • • • • • • • • • • • • • • • • • • Always connect the product to a grounded circuit to avoid the risk of electrocution.
2. INTRODUCTION Product Overview Mounting Bracket Zoom Thumbscrew Focus Thumbscrew Bracket Adjustment Knob Gobo Holder Thumbscrew Fan Display Menu Buttons Fuse Holder Power In D-Fi USB Port Power Out DMX In/Out Safety Cable Pass-Through WARNING! DO NOT plug anything other than a D-Fi USB into the USB port. Doing so may cause damage to the product. Gobo Zoom USB User Manual Rev.
Product Dimensions 9.6 in 244 mm 9.4 in 238 mm 4.9 in 124 mm Page 6 of 16 Gobo Zoom USB User Manual Rev.
3. SETUP AC Power The Gobo Zoom USB has an auto-ranging power supply and it can work with an input voltage range of 100 to 240 VAC, 50/60 Hz. To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. The listed current rating indicates the product’s average current draw under normal conditions.
Mounting Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes. Orientation The Gobo Zoom USB may be mounted in any position; however, make sure adequate ventilation is provided around the product. Rigging • Before deciding on a location for the product, always make sure there is easy access to the product for maintenance and programming purposes. • Make sure that the structure onto which you are mounting the product can support the product’s weight.
4. OPERATION Control Panel Operation To access the control panel functions, use the four buttons located underneath the display. Please refer to the Product Overview to see the button locations on the control panel.
D-Fi USB Connectivity The Gobo Zoom USB is able to become a D-Fi wireless receiver/transmitter with the use of the D-Fi USB from CHAUVET DJ. Simply set the product's DMX Personality and DMX Address, set the DIP switch D-Fi receiving/transmitting channel, then plug it into the D-Fi USB port. WARNING! DO NOT plug anything other than a D-Fi USB into the USB port. Doing so may cause damage to the product. Once plugged in, the D-Fi USB will take over the product.
Configuration (Standalone) Set the product in one of the standalone modes to control without a DMX controller. • Connect the product to a suitable power outlet. Never connect a product that is operating in any standalone mode to a DMX string connected to a DMX controller. Products in standalone mode may transmit DMX signals that could interfere with the DMX signals from the controller.
Master/Slave Mode (wired) The Master/Slave mode allows a single Gobo Zoom USB product (the master) to control the actions of one or more Gobo Zoom USB products (the slaves) without the need of a DMX controller. The master product will be set to operate in either Stand-Alone mode or with the IRC-6, while the slave products will be set to operate in Slave mode. Once set and connected, the slave products will operate in unison with the master product. Configure the products as indicated below.
5. MAINTENANCE Product Maintenance Dust build-up reduces light output performance and can cause overheating. This can lead to reduction of the light source’s life and/or mechanical wear. To maintain optimum performance and minimize wear, clean your lighting products at least twice a month. However, be aware that usage and environmental conditions could be contributing factors to increase the cleaning frequency. To clean the product, follow the instructions below: 1. Unplug the product from power. 2.
6. TECHNICAL SPECIFICATIONS Dimensions and Weight Length Width Height Weight 9.4 in (238 mm) 4.9 in (124 mm) 9.6 in (244 mm) 4.4 lb (12.1 kg) Note: Dimensions in inches rounded to the nearest decimal digit. Power Light Source Photometrics Thermal DMX Ordering Page 14 of 16 Power Supply Type Range Voltage Selection Switching (internal) 100 to 240 VAC, 50/60 Hz Auto-ranging Parameter 120 V, 60 Hz 230 V, 50 Hz Consumption 41 W 39 W Operating Current 0.7 A 0.
RETURNS To get support or return a product: • If you are located in the U.S., contact Chauvet World Headquarters. • If you are located in the UK or Ireland, contact Chauvet Europe Ltd. • If you are located in Mexico, contact Chauvet Mexico. • If you are located in Benelux, contact Chauvet Europe BVBA. • If you are located in any other country, DO NOT contact Chauvet. Instead, contact your local distributor. See www.chauvetlighting.com for distributors outside the U.S., UK, Ireland, Mexico, or Benelux.
CONTACT US USA WORLD HEADQUARTERS General Information – Chauvet Address: 5200 NW 108th Avenue Sunrise, FL 33351 Voice: (954) 577-4455 Fax: (954) 929-5560 Toll free: (800) 762-1084 Technical Support Voice: (954) 577-4455 (Press 4) Fax: (954) 756-8015 Email: tech@chauvetlighting.com World Wide Web www.chauvetlighting.com EUROPE General Information - Chauvet Europe BVBA Address: Stokstraat 18 9770 Kruishoutem Belgium Voice: +32 9 388 93 97 Technical Support Email: Eutech@chauvetlighting.
