User Manual

Page 12 of 16 Gobo Zoom USB User Manual Rev. 4
Master/Slave
Mode
(wired)
The Master/Slave mode allows a single Gobo Zoom USB product
(the master) to control
the actions of one or more Gobo Zoom USB product
s (the slaves) without the need of a
DMX controller. The master product will be set to operate in either Stand-Alone mode or
with the IRC-6, while the slave products will be set to operate in Slave mode. Once set and
connected, the slave products will operate in unison with the master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU> repeatedly until 2-CH shows on the display.
2. Press <ENTER> to accept.
3. Set the DMX address to d 1.
4. Connect the DMX input of the first slave product to the DMX output of the master
product.
5. Connect the DMX input of the subsequent slave products to the DMX output of the
previous slave product.
6. Finish setting and connecting all the slave products.
Master product:
1. Set the rotation direction and speed on the master product.
2. Make the master product the first product in the DMX daisy chain.
• Configure all the slave product
s before connecting the master to the daisy
chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the master.
• Do not connect more than 31 slaves to the master.
Master/Slave
Mode
(D-Fi USB)
The D-Fi USB allows a single Gobo Zoom USB product
(the master) to control the actions
of one or more Gobo Zoom USB product
s (the slaves) without the need of a DMX
controller or DMX cables. The master (transmitter) product
will be set to operate in either
Stand-Alone mode or with the IRC-6, while the slave (receiver) product
s will be set to
operate in Slave mode. Once set and connected, the slave product
s will operate in unison
with the master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU> repeatedly until 2-CH shows on the display.
2. Press <ENTER> to accept.
3. Set the DMX address to d 1.
4. Set the D-Fi USB to receive on a specific channel, 1–16.
5. Plug in the D-Fi USB.
6. Finish setting and connecting all the slave products.
Master product:
1. Press <MENU> repeatedly until 2-CH shows on the display.
2. Press <ENTER> to accept.
3. Set the DMX address to d 1.
4. Set the rotation direction and speed on the master product.
5. Set the D-Fi USB to transmit on the D-Fi channel the slaves are receiving on.
6. Plug in the D-Fi USB.
• All products must be set to the same DMX personality, DMX address, and D-Fi
channel.
• Configure all the slave products before configuring the master to transmit.
• Never connect a DMX controller to a D-Fi channel
configured for Master/Slave
operation because the controller may interfere with the signals from the master.