Manualshelf

User Manual

ManualsBrandsChauvet DJ ManualsMobile Heads and ScannersIntimidator Scan 305 IRC
18192021222324252627
Intimidator Scan/Barrel 305 IRC User Manual Rev. 1 Page 23 of 27
Configuration
(Master/Slave)
Master/Slave mode allows a single Intimidator Scan/Barrel 305 IRC (the master) to control
the actions of one or more Intimidator Scan/Barrel 305 IRCs (the slaves) without
a DMX
controller.
In Master/Slave mode the master is set to operate in Auto mode, Sound mode,
or IR
mode and the slaves are set to operate in Slave mode.
The master and slaves are daisy chained though the DMX input and output ports with the
master at the beginning of the chain. Once set and connected, the slave
s will operate
identically to, and in unison with, the master.
• Always put the male DMX connector into the master. Do not connect to the
DMX In port on the master.
• Never connect more than 31 slaves to the master.
• Never connect a DMX controller to a DMX daisy chain of master and slaves.
• Configure all the slaves before connecting the master to the DMX daisy chain.
Configuring the
Slaves
Configure the slaves for Slave mode before or after they are put in position, and before
they are daisy chained to the master.
To configure a slave, do the following:
1. Make sure the product is connected to a power source.
2. Press <MENU> repeatedly until 4 icons show on the display.
3. Use <UP> or <DOWN> to highlight the Run Mode icon.
4. Press <ENTER>. The Run Mode options will show on the display.
5. Use <UP> or <DOWN> to highlight the Slave option.
6. Press <ENTER>. The current Slave mode will be highlighted.
7. Use <UP> or <DOWN> to select the Slave mode.
• Select Slave1 for 100% synchronized actions.
• Select Slave2, Slave3, or Slave4 for a delayed show, creating a wave effect.
Configuring the
Master
Configure the master after all the slaves are connected to it and configured.
To configure the master, do the following:
1. Make sure the product is connected to a power source and connected to all of
the
slaves.
2. Press <MENU> repeatedly until 4 icons show on the display.
3. Use <UP> or <DOWN> to highlight the Run Mode icon.
4. Select any of the Standalone modes as described in Configuration (Standalone).