User Manual Model ID: AMHAZEECO 220AMHAZEECO
Edition Notes The AmHaze ECO User Manual includes a description, safety precautions, installation, programming, operation and maintenance instructions for the AmHaze ECO as of the release date of this edition. Trademarks CHAUVET, the Chauvet logo and AmHaze ECO are registered trademarks or trademarks of Chauvet & Sons, LLC (d/b/a Chauvet and Chauvet Lighting) in the United States and other countries.
Table of Contents TABLE OF CONTENTS 1. Before You Begin ......................................................................................... What Is Included ...................................................................................................... Claims ...................................................................................................................... Text Conventions .....................................................................................................
Before You Begin 1. Before You Begin What Is Included • • AmHaze ECO Seetronic Powerkon IP65 power cord • Quick Reference Guide Claims Carefully unpack the product immediately and check the container to make sure all the parts are in the package and are in good condition. If the box or the contents (the product and included accessories) appear damaged from shipping, or show signs of mishandling, notify the carrier immediately, not Chauvet.
Before You Begin Safety Notes Read all the following safety notes before working with this product. These notes contain important information about the installation, usage, and maintenance of this product. This product contains no user-serviceable parts. Any reference to servicing in this User Manual will only apply to properly trained, certified technicians. Do not open the housing or attempt any repairs. All applicable local codes and regulations apply to proper installation of this product.
Introduction 2. Introduction Description The AmHaze ECO is a professional water-based haze machine that delivers high output while utilizing economic fluid consumption. With a 30-second heat up time and continuous output that doesn’t require reheating, a single fluid container at the maximum output of 120 cfm will last over 8 hours. Easily control the output and fan speed via DMX or on the on-board control knobs.
Setup 3. Setup AC Power The AmHaze ECO has a fixed power supply that works with an input voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific model. To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. The listed current rating indicates the product’s average current draw under normal conditions.
Setup Mounting Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes. For our CHAUVET Professional line of mounting clamps, go to http://trusst.com/products/. Orientation Always mount this product in a safe position, making sure there is adequate room for ventilation, configuration, and maintenance. Rigging Chauvet recommends using the following general guidelines when mounting this product.
Operation 4. Operation Control Panel Description Button
Operation RDM Chart Sensors Page 7 of 14 Detail Chauvet SET Allowed RDM Parameter ID's (Slots 21-22) Value DISC_UNIQUE_BRANCH 0x0001 DISC_MUTE 0x0002 DISC_UN_MUTE 0x0003 Network Management PROXIED_DEVICES 0x0010 PROXIED_DEVICE_COUNT 0x0011 COMMS_STATUS 0x0015 QUEUED_MESSAGE 0x0020 STATUS_MESSAGES 0x0030 Status STATUS_ID_DESCRIPTION 0x0031 Collection CLEAR_STATUS_ID 0x0032 SUB_DEVICE_STATUS_REPORT_TH 0x0033 RESHOLD SUPPORTED_PARAMETERS 0x0050 RDM Information
0x0400 LAMP_HOURS 0x0401 0x0402 0x0403 0x0404 0x0405 0x0440 0x0500 0x0501 0x0600 0x0601 0x0602 0x0603 0x0640 0x0641 0x0642 0x0700 0x0701 0x0702 0x0703 0x0704 0x0705 0x0706 0x0707 0x0708 LAMP_STRIKES LAMP_STATE LAMP_ON_MODE DEVICE_POWER_CYCLES BURN_IN DISPLAY_INVERT Display Settings DISPLAY_LEVEL PAN_INVERT TILT_INVERT PAN_TILT_SWAP REAL_TIME_CLOCK Configuration LOCK_PIN LOCK_STATE LOCK_STAT
Control Chauvet Value 0x1000 0x1001 0x1010 0x1020 0x1021 0x1030 0x1031 0x1040 0x1041 0x1042 0x1043 0x1044 SET Allowed RDM Parameter ID's (Slots 21-22) IDENTIFY_DEVICE RESET_DEVICE POWER_STATE PERFORM_SELFTEST SELF_TEST_DESCRIPTION CAPTURE_PRESET PRESET_PLAYBACK IDENTIFY_MODE PRESET_INFO PRESET_STATUS PRESET_MERGEMODE POWER_ON_SELF_TEST GET Allowed Category Required Operation Detail Yes/No Primes Unit Primes Unit Configuration (DMX) Use control co
Operation Configuration (Settings) RDM-UID To view the RDM-UID of the product, go to the RDM-UID level. Fluid Sensor To enable or disable the fluid sensor function: 1. Go to the Fluid Sensor level. 2. Select from ON or OFF. Auto Run Last Setting To set the control values to the last ones used: 1. Go to the Auto Run Last Setting level. 2. Select from YES or NO. Auto Shutdown To shut all functions down: 1. Go to the Auto Shutdown level. 2. Select from ON or OFF. AmHaze ECO User Manual Rev.
Maintenance 5. Maintenance Product Maintenance Do not allow the haze machine to become clogged. After every 40 hours of continuous operation, use CHAUVET Fog Cleaner Quart (FCQ) through the system to prevent the accumulation of particulate matter in the heating element. The recommended cleaning procedure is as follows. 1. Unplug the product from power. 2. Empty all fluid from the machine. 3. Add cleaning solution to the tank. 4. Connect the product to power and allow it to warm up. 5.
Technical Specifications 6. Technical Specifications Dimensions and Weight Length 15.86 in (403 mm) Width 12.20 in (310 mm) Note: Dimensions in inches are rounded. Power Power Supply Type Height 10.07 in (256 mm) Weight 25 lb (11.4 kg) Voltage Selection Fixed Range 120 VAC, 60 Hz or 230 VAC, 50 Hz Parameter Consumption Operating Current 120 V, 60 Hz 1,230 W 10.25 A 230 V, 50 Hz 2,430 W 10.56 A Power I/O Power Input Connector Power Cord plug U.S./Worldwide Seetronic Powerkon IP65 Edison (U.S.
Returns Returns Send the product prepaid, in the original box, and with the original packing and accessories. Chauvet will not issue call tags. Call Chauvet and request a Return Merchandise Authorization (RMA) number before shipping the product. Be prepared to provide the model number, serial number, and a brief description of the cause(s) for the return. To submit a service request online, go to www.chauvetprofessional.com/service-request. Clearly label the package with an RMA number.
Contact Us Contact Us General Information Technical Support Chauvet World Headquarters Address: 5200 NW 108th Ave. Sunrise, FL 33351 Voice: (954) 577-4455 Fax: (954) 929-5560 Toll Free: (800) 762-1084 Voice: (844) 393-7575 Fax: (954) 756-8015 Email: chauvetcs@chauvetlighting.com Website: www.chauvetprofessional.com Chauvet Europe Ltd Address: Unit 1C Brookhill Road Industrial Estate Pinxton, Nottingham, UK NG16 6NT Voice: +44 (0) 1773 511115 Fax: +44 (0) 1773 511110 Email: UKtech@chauvetlighting.
