User manual
Table Of Contents
Page 16 of 20 Intimidator™ Spot 100 IRC User Manual
Manual Pan/Tilt
Operation
To select whether you want the Intimidator™ Spot 100 IRC to operate with normal
panning or inverted panning, do the following:
1. Press <MODE/ESC> repeatedly until PAn (normal) or rPAn
(inverted) shows on the
display.
2. Use <UP> or <DOWN> to select the desired pan operation.
3. Press <ENTER>.
To select whether you want the Intimidator™ Spot 100 IRC to operate with normal tilting
or inverted tilting, do the following:
1. Press <MODE/ESC> repeatedly until tit (normal) or rtit (inverted) shows on the
display.
2. Use <UP> or <DOWN> to select the desired tilt operation.
3. Press <ENTER>.
Pan/Tilt Angle
Range
You are able to select the range for the pan and tilt angles on the Intimidator™ Spot 100
IRC to achieve the effect you like.
To select the pan angle range, do the following:
1. Press <MODE/ESC> repeatedly until PA54 (540°), PA36 (360°), or PA18 (180°)
shows on the display.
2. Use <UP> or <DOWN> to select the desired pan angle range.
3. Press <ENTER>.
To select the tilt angle range, do the following:
1. Press <MODE/ESC> repeatedly until Ti27 (270°), Ti18 (180°), or Ti 9 (90°) shows
on the display.
2. Use <UP> or <DOWN> to select the desired tilt angle range.
3. Press <ENTER>.
Display
Orientation
You are able to flip the LED display for easy readability in any mounting situation.
To select your display angle:
1. Press <MODE/ESC> repeatedly until diS (normal) or rdiS (inverted) shows on the
display.
2. Use <UP> or <DOWN> to select the desired orientation.
3. Press <ENTER>.
Temperature
Display
To view the LED’s temperature, follow the instructions below:
1. Press <MODE/ESC> repeatedly until tCXX shows on the display. The temperature
will be shown in degrees Celsius.
Reset Software
To reset the software in the Intimidator™ Spot 100 IRC, do the following:
1. Press <MODE/ESC> repeatedly until rESt shows on the display.
2. Press <ENTER
Load Factory
Defaults
To load the factory default settings in the Intimidator™ Spot 100 IRC, follow the
instructions below:
1. Press <MODE/ESC> and until LoAd shows on the display.
2. Press <ENTER>.