User Manual
TABLE OF CONTENTS 1. BEFORE YOU BEGIN.............................................................................................................................................................................3 SAFETY INSTRUCTIONS.................................................................................................................................................................................. 4 2. INTRODUCTION ...................................................................................
1. BEFORE YOU BEGIN What Is Included • • • • • 6Spot™ Power Cord Mounting Kit Warranty Card Quick Reference Guide Unpacking Instructions Carefully unpack the product immediately and check the container to make sure all the parts are in the package and are in good condition. Claims If the box or the contents (the product and included accessories) appear damaged from shipping, or show signs of mishandling, notify the carrier immediately, not CHAUVET®.
Safety Instructions Please read these instructions carefully. It includes important information about the installation, usage and maintenance of this product. • • • • • • • • • • • • • • Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.
3. SETUP AC Power This fixture is auto-ranging and runs on 100~240 VAC, 50/60 Hz power. To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its average current draw under normal conditions. Always connect the fixture to a switched circuit.
Mounting Orientation The 6SPOT™ may be mounted in any position, provided there is adequate room for ventilation. Rigging This fixture has multiple rigging options. They are as follows: Floor Standing (using the two mounting/standing brackets) Hanging (using the two mounting/standing brackets) Hanging (using the two hanging clamp Mounting points) Be sure that the structure can support the weight of the fixture. Please see the “Technical Specifications” section of this manual for a detailed weight listing.
4. OPERATING INSTRUCTIONS Using the Control Panel Access control panel functions using the four buttons located directly underneath the LED display.
Operation DMX Operation This operating mode will allow for control with an external DMX controller. You must set the starting address for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer” section in the “Appendix” of this manual. Please see the instructions below for details on this mode. 1. 2. 3. 4. 5. 6. Plug the fixture into power. Plug a DMX controller into the fixture in a daisy chain configuration.
Master/Slave Mode (Sound-Active) This mode allows a single unit, the master, to operate in either automatic or sound-active mode. When additional (slave) fixtures are daisy chained to the master, they will all synchronize with the master and run the same lighting show. Please see the instructions below for details on this mode. Master: 1. 2. Slave: 1. 2. Place the master fixture first in the daisy chain.
5. TECHNICAL INFORMATION Product Maintenance Dust build-up reduces light output performance and can cause overheating. This can lead to reduction of the light source’s life and/or mechanical wear. To maintain optimum performance and minimize wear, clean the product at least twice a month. However, usage and environmental conditions contribute to increased cleaning frequency. To clean the product, follow the instructions below: • Unplug the product from power.
Technical Specifications WEIGHT & DIMENSIONS Length ..............................................................................................................35.5 in (902 mm) Width .................................................................................................................... 2.2 in (56 mm) Height ................................................................................................................. 6.5 in (165 mm) Weight ...................................................
To return a product or request support: In the U.S., contact CHAUVET® World Headquarters (see below). In the UK or Ireland, contact CHAUVET® Europe Ltd. (see below). In any other country, DO NOT contact CHAUVET®. Contact your distributor. See www.chauvetlighting.com for distributors outside the U.S., United Kingdom, or Ireland. If you live outside the U.S., United Kingdom, or Ireland, contact your distributor of record and follow their instructions on how to return CHAUVET® products to them.