User manual

6Spot™ User Manual (Rev. 2) Page 8 of 12
Operation
DMX Operation
This operating mode will allow for control with an external DMX controller. You must set the
starting address for this mode.
If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer”
section in the “Appendix” of this manual.
Please see the instructions below for details on this mode.
1. Plug the fixture into power.
2. Plug a DMX controller into the fixture in a daisy chain configuration.
3. Press <MODE> until Addr appears on the LED screen.
4. Press <ENTER>.
5. Using <UP>&<DOWN>, select the DMX starting address.
6. Press <ENTER>.
DMX Channel Values
CHANNEL
VALUE
FUNCTION
1
000 ó 010
011ó 045
046ó 080
081ó 115
116ó 150
151ó 185
186ó 220
221ó255
Pod 1
Blackout
Red
Green
Blue
Yellow
Magenta
Cyan
White
2
000 ó 010
011ó 045
046ó 080
081ó 115
116ó 150
151ó 185
186ó 220
221ó255
Pod 2 (run speed when CH.8 is between 011~239)
Blackout
Red
Green
Blue
Yellow
Magenta
Cyan
White
3~6
000 ó 010
011ó 045
046ó 080
081ó 115
116ó 150
151ó 185
186ó 220
221ó255
Pod 3~6
Blackout
Red
Green
Blue
Yellow
Magenta
Cyan
White
7 000ó009
010ó255
Strobe
No function
Strobe (slow~fast)
8
000ó010
011ó047
048ó095
096ó119
120ó144
145ó167
168ó191
192ó215
216ó239
240ó255
Mode
Individual pod control with strobing (channels 1~7)
Automatic 1
Automatic 2
Automatic 3
Automatic 4
Automatic 5
Automatic 6
Automatic 7
Automatic 8
Sound-active