CH-222 Abyss™ Jr. USER MANUAL Chauvet, 3000 N 29th Ct, Hollywood, FL 33020 U.S.A (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.
TABLE OF CONTENT TABLE OF CONTENT ...................................................................................................................................................... 2 BEFORE YOU BEGIN ...................................................................................................................................................... 3 WHAT IS INCLUDED..........................................................................................................................................
BEFORE YOU BEGIN What is included 1 x Abyss™ Jr. (CH-222) Power cord with plug EFP5 100w lamp Warranty Card & Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling.
INTRODUCTION The Abyss Jr. projects a wave simulation effect on a wall or any flat surface. It is a wonderful scenic effect that adds life and color to any venue.
SETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. An EFP 100W halogen lamp is included. Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect from main power prior to lamp replacement. Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp with alcohol and wipe it with a lint free cloth before installation.
OPERATING INSTRUCTIONS The Abyss Jr. is a water ripple or undulation simulation effect that requires no additional connections or a controller to operate. It is especially functional when used to project on a light colored surface, preferably a pastel or white.
APPENDIX General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance and can cause overheating. This can lead to reduced lamp life and increased mechanical wear. Be sure to power off fixture before conducting maintenance. Unplug fixture from power.
Appendix General Troubleshooting Applies to Symptom Solution(s) Auto shut off Check fan thermal switch reset Beam is very dim or not bright Clean optical system or replace lamp Breaker/Fuse keeps blowing Check total load placed on device Chase is too slow Check users manual for speed adjustment Device has no power Check for power on Mains. Lights Controllers Dimmers & Chaser Check 220/110v switch for proper setting Check device’s fuse.
Appendix Technical Specifications WEIGHT & DIMENSIONS Length.............................................................................................................................178 mm (7 in) Width.......................................................................................................................... 159 mm (6.25 in) Height .............................................................................................................................102 mm (4 in) Weight...............
