User manual

Arena™ 2100 Flex User Manual (Rev. 05) Page 9 of 19
4. OPERATION
Control
Panel
Operation
To access the control panel functions, use the four buttons located underneath the
display. Please refer to the Product Overview (page 5) to see the button locations on
the control panel.
Button Function
<FUNCTION>
Press to find an operation mode or to back out of the current menu
option
<UP>
Press to scroll up the list of options or to find a higher value
<DOWN>
Press to scroll down the list of options or to find a lower value
<TIMER>
Turns on Timer Mode
<VOLUME>
Turns on Volume Mode
<MANUAL>
Controls fog output manually
Menu Map
Mode Programming Steps Description
Interval Set
1-200
Adjusts the fog output interval (in
seconds)
Duration Set
1-200
Adjusts the fog output interval (in
seconds)
Timer Out
1-100%
Adjusts the fog output volume of Timer
Mode
Volume Out
1-100%
Adjusts the fog output volume of Volume
Mode
DMX 512 Add
1-512
Sets the DMX address
Wireless On
On Off
Turns the wireless function on or off
Configuration
(DMX)
Set this product in DMX mode to control with a DMX controller.
1. Connect this product to a suitable power outlet.
2. Turn this product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket of this product.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you
could restrict the access to some of the product’s channels.
The Arena™ 2100 Flex uses one DMX channel in its 1-channel DMX mode, which
defines the highest configurable address to 512.
If you are not familiar with the DMX protocol, you may refer to the DMX Primer section
in the Technical Information chapter.
To select the starting address, do the following:
1. Press <FUNCTION> repeatedly until DMX 512 Add shows on the display.
2. Use <UP> or <DOWN> to select the starting address.