User manual

Atmos™ QRG EN

Mounting

Before mounting this product, read the Safety Notes. Make sure the mounting clamp

is capable of supporting the weight of the product. For our Chauvet line of mounting

clamps, go to trusst.com/productcategory/base-plates-accessories-clamps/.

Product

Mounting

Diagram

Control Panel

Description

Button

Function

Enters the programming mode

Controls the pump to modify the output volume

<TIMER>

Starts the timer controlled operation

Allows momentary fog output for as long as the button is

held down

<UP>

Navigates upward through the menu list or increases the

numeric value when in a function

<DOWN>

Navigates downward through the menu list or decreases the

numeric value when in a function

Preparing for

Operation

To prepare the Atmos™ for operation:

1. Pull out the fluid tank and remove the cap.

2. Verify that the two plastic hoses attached to the cap are in place and in good

condition.

3. Pour Chauvet (HDF or QDF) fluid inside the tank and re-cap.

4. Reinsert the tank.

5. Make sure that the plastic hose that goes from the cap to the Atmos™ is not

bent.

6. Plug in power and wait approximately 8 minutes for warm-up to complete.

Secure the safety cable using

the safety loops

on the

product.

Secure the safety cable using

the safety loops on the

product

Overhead Mounting

Floor Mounting

Mounting Clamp

Safety Cable