Bubble Machine User Manual
TABLE OF CONTENTS 1. Before You Begin .............................................................................. 3 What Is Included ............................................................................................... 3 Unpacking Instructions ...................................................................................... 3 Claims ........................................................................................................................ 3 Text Conventions ..................
1. BEFORE YOU BEGIN What Is Included • • B-250 Bubble Machine Hanging Bracket with Mounting Hardware • • • Power Cord Warranty Card Quick Reference Guide Unpacking Instructions Immediately upon receipt, carefully unpack the product and check the container to make sure you have received all the parts indicated above in good condition.
Product at a Glance Use on Dimmer Outdoor Use Sound-Active DMX Master/Slave Safety Notes Auto Programs Fixed voltage (120 V or 230 V) Replaceable Fuse User-Serviceable x P P x Please read the following Safety Notes carefully before working with the product. The Notes include important safety information about installation, usage, and maintenance. • • • • • • • • • • • • • • • • • • Page 4 of 10 x x x x x Always connect the product to a grounded circuit to avoid the risk of electrocution.
2. INTRODUCTION Product Overview Mounting Bracket Bracket Adjustment Knob Fuse Holder Power In On/Off Switch B-250 Bubble Machine User Manual Rev.
3. SETUP AC Power The B-250 Bubble Machine has a fixed voltage power supply and can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific model. To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specification chart. The listed current rating indicates the product’s average current draw under normal conditions.
Mounting Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes section. Orientation The Bubble Machine may be mounted in any position; however, make sure adequate ventilation is provided around the product. Rigging • Before deciding on a location for the product, always make sure there is easy access to the product for maintenance and fluid replenishment purposes.
4. OPERATION Operation 1. 2. 3. 4. 5. Place the Bubble Machine on a level surface and loosen the thumbscrews on the front for fluid tank access. Lift the cover. Fill the tank with bubble fluid. Note: We recommend using CHAUVET® bubble fluid (BJU) which has been specially formulated for use with CHAUVET® bubble machines. The tank capacity is 24 oz (0.7 l). Lower the cover and tighten screws. Plug into a suitable wall outlet. Turn on the Bubble Machine.
5. TECHNICAL INFORMATION Product Maintenance Dust build-up reduces output performance and can cause overheating. This can lead to reduction of the product’s life and mechanical wear. To maintain optimum performance and minimize wear, you should clean your products frequently. However, be aware that usage and environmental conditions could be contributing factors to increase the cleaning frequency.
Contact Procedure CHAUVET® Contact Information In case you need to return a product or request support, follow the procedure below: • • • If you live in the U.S., contact CHAUVET® World Headquarters (see below). If you live in the UK or Ireland, contact CHAUVET® Europe Ltd. (see below). If you live in any other country, DO NOT contact CHAUVET®. Instead, contact your distributor of record. Refer to our Web site for contact details of distributors outside the US, United Kingdom, or Ireland.
