User manual

Page 14 of 21 Scorpion™ BLU User Manual (Rev. 6)
Menu Options
Branch Programming Steps Description
Auto/Sound
AFn
Fast program
ASn
Slow program
Son
Sound activated program
rdn
Randomly selects an operation mode
Laser Sky
Mode
LSE
Laser sky effect
LSS
Sound triggered laser sky effect strobes
Laser Sky
Angle
LSU
Laser sky effect position setting
Sound
sensitivity
S 0~S 9
Adjusts the internal microphone’s sensitivity
DMX
001~503
Selects the DMX starting address (1~503)
Slave SLA
Sets the product as “Slave” for master/slave
operation
Reverse rEv
P-y/P-n
Reverses pan movement direction
t-y/t-n
Reverses tilt movement direction
Configuration
DMX Mode
Setting this product to operate in DMX mode will allow you to control it with a DMX
controller.
1. Connect this product to a suitable power outlet.
2. Turn this product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the
DMX input socket of this product.
Starting Address
When selecting a starting DMX address, you must always consider the number of
DMX channels assigned to the selected DMX mode. If you choose a starting address
that is too high, you could restrict the access to some of the channels of the DMX
mode in use.
The Scorpion™ BLU products use ten
DMX channels, which defines the highest
configurable address to 503.
If you are not familiar with the DMX
protocol, you may refer to the “DMX Primer”
section in the “Technical Information” chapter.
To select the starting address, do the following:
1. Press <MENU> repeatedly until the current starting address (001 to 503)
shows blinking on the display.
2. Use <UP> or <DOWN> to select a different starting address (001~503).
3. Press <ENT> (the new starting address will show solid on the display).
Standalone Modes
Never connect a product that is operating in any standalone mode, whether
Static, Automatic, or Sound to a DMX string connected to a DMX controller.
This is because products in standalone mode may transmit DMX signals that
could interfere with the DMX signals from the controller.
Setting this product to operate in DMX mode will allow you to control it without a DMX
controller.
1. Connect this product to a suitable power outlet.
2. Turn this product on.