User manual

Setup
-6- Legend™ 330SR Spot User Manual Rev. 2
3. SETUP
AC Power
Each Legend™ 330SR Spot has an auto-ranging power supply that works with an input voltage
range of 100 to
240 VAC, 50/60 Hz. To determine the power requirements for each
Legend™ 330SR Spot
, refer to the label affixed to the product. You can also refer to the
Technical Specifications chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, you may download Sizing Circuit Breakers from the CHAUVET® website
:
www.chauvetlighting.com/download/pro.
Always connect this product to a protected circuit with an appropriate electrical ground
to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
AC Plug
The Legend™ 330SR Spot comes with a power input cord terminated with a Neutrik®
powerCON® A connector on one end and has been left bare-wired on the other end. U
se the
table below to wire a new plug.
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow or Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
Fuse
Replacement
1. Disconnect this product from the power outlet.
2. Using a Phillips-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a another fuse of the same type and rating
(T 10 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
Make sure to disconnect the product’s power cord before replacing a blown fuse. Always
replace the blown fuse with another of the same type and rating.
DMX Linking
You can link the Legend™ 330SR Spot to a DMX controller using a 3- or 5-pin DMX connection.
If using other DMX-compatible products with the Legend™ 330SR Spot
, you can control each
individually with a single DMX controller.
DMX
Personalities
The Legend™ 330SR Spot uses a 3- or 5-pin DMX data connection for the 21- and 27-channel
DMX personalities.
• Refer to the Introduction chapter for a brief description of each DMX personality.
• Refer to the Operation chapter to learn how to configure the Legend™ 330SR Spot to work
in these personalities.
• The DMX Values section provides you with detailed information regarding the DMX
personalities.
If you are not familiar with or need more information about DMX standards, Master/Slave
connectivity, or the DMX cables needed to link this product to a DMX controller,
download the DMX Primer from the CHAUVET® website:
www.chauvetlighting.com/download/pro.