User manual

Operation
-16- Legend™ 330SR Spot User Manual Rev. 2
Lamp Settings
From the Main Menu, highlight Lamp Settings and press <ENTER>.
The lamp will not turn on if the ambient temperature is 104 ºF (40 ºC) or higher.
Lamp On/Off
1. Highlight On/Off.
2. To turn the lamp on or off, press <ENTER>.
a. Select ON to turn the lamp on or OFF to turn the lamp off.
b. Accept the selected option.
Lamp Status During Power
On
1. Highlight State/Power On.
2. To change the lamp status during power on, press <ENTER>.
a. Select ON to turn on the product and the lamp simultaneously or OFF
to turn on
the product without turning on the lamp.
b. Accept the selected option.
Remote Turn Off
1. Highlight Off Via DMX.
2. To enable/disable remote turn off, press <ENTER>.
a. Select YES to enable product turn off from either a DMX controller or its power
switch, or NO to turn the product off only from its power switch.
b. Accept the selected option.
Lamp On if DMX Present
1. Highlight On if DMX On.
2. To turn the lamp on when DMX is present, press <ENTER>.
a. Select YES to turn the lamp on if DMX signal is present, or NO to turn the lamp
on only from the control panel.
b. Accept the selected option.
Lamp Off if DMX Absent
1. Highlight Off if DMX Off.
2. To turn the lamp off when DMX is absent, press <ENTER>.
a. Select YES to turn the lamp off if DMX signal is absent, or NO to turn the lamp
off only from the control panel.
b. Accept the selected option.
Lamp Strike Delay
1. Highlight Ignition Delay.
2. To set the lamp strike delay, press <ENTER>.
a. Select the delay before the lamp strikes after power up in seconds (0S–255S).
b. Accept the new value.
Fixture Shut Off Delay
1. Highlight Low Power Delay.
2. To set the lamp shut off delay, press <ENTER>.
a. Select the delay before the product powers off after lamp off in seconds
(0S–255S).
b. Accept the new value.