Hurricane™ 1100 Snapshot OK on Dimmer F-1100 Outdoor OK Sound Activated DMX512 Master/Slave 115V/230V Switch Replaceable Fuse User Serviceable Duty Cycle USER MANUAL 3000 N 29th Ct, Hollywood, FL 33020 U.S.A. (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.
TABLE OF CONTENTS 1. Before You Begin ................................................................................................................................ 2 What is included ....................................................................................................................................... 2 Unpacking Instructions .............................................................................................................................. 2 AC Power ...........................
AC Power To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating is its average current draw under normal conditions. All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.
2. INTRODUCTION Features Output: 8,000cfm 1.
Product Overview Hanging bracket Fluid container Safety cable eye bolt Tilt Adjustment knob Heater Nozzle Manual Fog button Low Fluid indicator Fluid level indicator Manual Controller Wireless Controller Power input (hardwired) Fuse holder Hurricane™ 1100 User Manual 5 3/26/2009 3:17 PM
Disconnect the power cord before replacing a fuse and always replace with the same type fuse. Fuse Replacement With a flat head screwdriver wedge the fuse holder out of its housing. Remove the damaged fuse from its holder and replace with exact same type fuse. Insert the fuse holder back in its place and reconnect power. The fuse is located inside this compartment. Remove using a flat head screwdriver. Mounting O RI ENT AT I O N This fixture should only be mounted/used on a flat surface.
5. OPERATING INSTRUCTIONS Operation This mode will allow you to control the fogger manually, set the fog machine to run continuously, or to set the fog machine to run off bursts with adjustable interval and duration settings. Manual Remote Operation (FC-M) (Standard) 1) Plug in the fog machine to power. 2) Plug in the M remote to the Manual Controller socket on the rear of the fog machine. 3) Press the single button located on the remote to trigger the fog output.
Wireless Controller (FC-W) (Optional) This mode will allow you to control the fogger using the optional wireless controller. This consists of the transmitter and the receiver. You may control up to 4 independent fog machines, or many more if you run them simultaneously. See the below instructions on setting up your fogger to operate with the FC-W. 1) Plug the wires receiver into the fog machine 5-pin port labeled “Wireless Controller”.
Hurricane™ 1100 General Troubleshooting Symptom No Power No fog output Breaker/Fuse keeps blowing Low fog output Fog machine is not heating up Remote does not work Fluid indicator states no fog, but the container if full. Solution(s) Check mains power. Check external fuse. Check internal fuse. Check fluid level. Check remote. If using wireless, check batteries. If using wireless, check dipswitches on receiver. Possible electrical short.
6. APPENDIX General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance and can cause overheating. This can lead to reduced lamp life and increased mechanical wear. Be sure to power off fixture before conducting maintenance. Unplug fixture from power.
Blow-out Diagram. 10 9 7 3 5 1 12 8 11 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Description Master PCB 120V Master PCB 220V Heater 700W 550° Celsius 120V Heater 700W 550° Celsius 220V Pump 120V Pump 220V Fluid container 1.
Connections Drawing In the event that any part(s) may need to be replaced/repaired, you may use the below diagram to assist in this operation. Warning: All repairs should only be performed by Authorized Service Personnel.
Technical Specifications WEIGHT & DIMENSIONS Length ................................................................................................................................ 9.7 in (247 mm) Width .................................................................................................................................. 9.6 in (243 mm) Height ................................................................................................................................. 8.7 in (220 mm) Weight ..