Specifications

Cirrus™ User Manual 9 8/18/2011
Han
g
in
g
Clam
p
Note!
Clamp is sold separately .
3. SETUP
AC Power
This product requires an external power supply, which is included. The included power
supply is rated for an input of 100~240 VAC, 50/60 Hz, and an output of 5 V, 3 A.
Before powering on the unit, make sure the line voltage to which you are connecting it is
within the range of accepted voltages. Only use the included power supply! To obtain a
replacement power supply, contact Chauvet®.
To determine the power requirements for a particular product, see the label affixed to the
back plate of the product or refer to the product’s specifications chart. A product’s listed
current rating indicates the average current draw under normal conditions.
Always connect the product to a switched circuit. Never connect the product to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only
as a 0 to 100% switch.
Mounting
Orientation
This product may be mounted in any safe position, provided there is adequate room for ventilation.
Rigging
It is important never to obstruct the fan or vents pathway. Mount the product using, a suitable “C” or “O” type
clamp. Adjust the angle of the product by loosening both knobs and tilting the product. After finding the
desired position, retighten both knobs.
 When selecting installation location, take into consideration access and routine maintenance.
 Safety cables must always be used.
 Never mount in places where the product will be exposed to rain, high humidity, extreme temperature
changes or restricted ventilation.
 Do not use any tool on the bracket adjustment knob. Hand-tighten only!
Power Supply