User guide

Operation
This lighting controller has been designed to function on a mains power supply of 120V, 60Hz or 230V, 50Hz and has been
supplied with a suitable power adapter.
To connect the controller to the COLORtube, please see the system diagram on page 2. Once the LED-CHV has been connected
to the COLORtubes and the power turned on, Press button E to select the desired mode. Then press button D to select the
options. Buttons B & C are then used to select the desired parameters (speed, strobe and color where applicable)
Mode Option (Button E) Available Colors
Static Color Red, Green, Yellow, Blue, Purple, Cyan, White
Mode Option (Button E) Set up Option (Button D) Up/Down (Buttons B&C)
Color Change Run Speed 1-100 (2 min - 5 sec)
Flash Frequency 1-100 (slow - Fast) 100 = Static
Slow Flow 1 Run Speed 1-100
Flash Frequency 1-100
Slow Flow 2 Run Speed 1-100
Flash Frequency 1-100
Roll Chase 1 Run Speed 1-100
Flash Frequency 1-100
Roll Chase 2 Run Speed 1-100
Flash Frequency 1-100
Multi-color Run Speed 1-100
Flash Frequency 1-100
Fast Flow 1 Run Speed 1-100
Flash Frequency 1-100
Fast Flow 2 Run Speed 1-100
Flash Frequency 1-100
2 Color Chase Run Speed 1-100
Flash Frequency 1-100
Color Selection (see note 1) 0-20
2 Color Flow Run Speed 1-100
Flash Frequency 1-100
Color Selection (see note 1) 0-20
Color Fade Run Speed 1-100
Flash Frequency 1-100
Auto Run Run Speed 1-100
Flash Frequency 1-100
System Mode COLORtube Address Setting Yes / No (see note 2)
Number of Tubes 0-1000
DMX Address 0-508 (see note 3)