User manual

CORE™ 3x1 User Manual Rev. 1 Page 11 of 20
Configuration
(DMX)
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a startin
g address that is too high, you could
restrict the access to some of the product’s channels.
The CORE™ 3x1 uses up to 13 DMX channels in its 13-channel
DMX mode, which
defines the highest configurable address to 500.
If unfamiliar with DMX or DIP switches,
download the DMX Primer from
www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <MENU> repeatedly until 3-CH, 5-CH, 9-CH, 10CH, or 13CH shows on the
display.
2. Press <ENTER> to activate the selected DMX personality and d 1–d512 shows on
the display.
3. Use <UP> or <DOWN> to select the starting address.
4. Press <ENTER>.
CORE™ 3x1 Sections for DMX Control
Section 1 Section 2 Section 3