User manual

FADE TIME ASSIGN (OPTIONAL SETUP)
You can choose whether the board’s fade time during scene execution is implemented broadly to all
output channels or only to the Pan and Tilt movement channels. This is relevant because often you
will want gobos and colors to change quickly while not affecting the movement of the light.
Action 
1) Turn OFF the controller.
2) Hold the BL
ACKOUT and TAPSYNC
buttons simultaneously.
3) Turn ON the controller.
4) Press the TA
PSYNC button to toggle
between the two modes. Either all channels
(A) or select channel Pan & Tilt only (P)
5) Press BL
ACKOUT and TAPSYNC to save
settings. All LED’s will blink to confirm.
Notes

Programming
A program (bank) is a sequence of different scenes (or steps) that will be called up one after another.
In the DMX-40B 30 programs can be created of 8 scenes in each.
ENTERING PROGRAM MODE
Press the PROGRAM button for 3 seconds until an LED dot next to the label PROG blinks. This
indicates that the user is in programming mode.
CREATE A SCENE
A scene is a static lighting state. Scenes are stored in banks. There are 30 bank memories on the
controller and each bank can hold 8 scene memories. The DMX-40B can save 240 scenes total.
Action 
1) Press and hold the PROGRAM button for 3
seconds.
2) Select a SC
ANNER (fixture) to program.
3) Compose a look by moving the FA
DERS.
(Changes in fixture attribute such as colors
and gobos.) Press PAGE SELECT to
access Channels 9~16 on the faders.
4) To program another SC
ANNER press the
SCANNER button you have just finished
programming then select another
SCANNER button to program.
5) Repeat steps 2 ~ 4 until you have your look.
6) Tap MIDI/
ADD button to prepare to store.
7) Choose a B
ANK (01~30). Use the Up and
Down arrow Bank buttons to change if
necessary.
8) Select a SCENES button to store.
All LED's
will blink 3 times. The display will now
display the bank and scene number that is
stored.
9) Repeat steps 2 ~ 8 to record more scenes.
( Read Imp
ortant notes on the right ->)
10) To exit program mode, hold the PR
OGRAM
button for 3 seconds. The controller will
default to a BLACKOUT when exiting the
programmer.
Notes

Deselect Blackout
if LED is lit.
A SCANNER button represents one l
ighting fixture.
You can access channels 9~16 by pr
essing the Page
Select button. This is necessary for fixtures that use
more than 8 channels of control. When switching
pages it will be necessary to move previously moved
faders up then down to activate.
Pressing the same Scanner button again will hold the
parameters chan
ged for that fixture in the program
scene.
There are 8 scenes available in every bank.
DMX-40B User Manual 10 Revised: 2006-11-10 09:50:14