User manual

Operation
-10- COLORado™ 1 Quad IP User Manual Rev. 1
DMX Personality
This setting allows you to choose a particular DMX personality.
1. Go to the PERS main level.
2. Select the desired personality (TOUR, ARC.1, AR1.D, ARC.2, AR2.D, AR2.S, or
HSV).
• See the DMX Values section for the highest starting address you can select for
each personality.
• Make sure that the starting addresses on the various products
do not overlap
due to the new personality setting.
DMX Control
In this mode, each product will respond to a unique starting address from the DMX
controller. All products with the same starting address will respond in unison.
1. Select a DMX personality as shown in DMX Personality.
2. Set the running mode:
a. Go to the RUN main level.
b. Select the DMX programming level.
3. Set the starting address:
a. Go to DMX main level.
b. Select the starting address (
001~512
).
The highest recommended starting address for each DMX mode are as follows:
DMX Mode DMX Address DMX Mode DMX Address DMX Mode DMX Address
TOUR
503
ARC.2
509
HSV
510
ARC.1
510
AR2.D
508
AR1.D
509
AR2.S
507
Loss of Signal
Setting
This setting controls how the product will respond when the DMX signal is lost.
1. Go to the SET main level, then select DERR.
a. Select SAVE to make the product use the last command used when the signal is
lost.
b. Select BLAK to turn off the all the LEDs when the signal is lost.
Static Color
The Static Color mode allows for permanent RGBW color mixing without a DMX controller.
1. Go to the STAT main level.
2. Select the desired color (RED, GREN, BLUE, or WHIT).
3. Select the desired color value (000~255).
4. Repeat for the other colors.
5. Select STRB.
6. Select the desired frequency (00~20).