User manual

Operation
COLORado™ 1 Quad IP User Manual Rev. 1 -13-
Reset
This setting allows you to reset the COLORado™ 1 Quad IP to the
default values,
including the custom programs.
1. Go to the SET main level.
2. Select REST.
3. When PASS shows, press <ENTER>.
4. Enter the master access password as described in Control Panel Lock.
5. Wait for the reset process to finish.
Whites Setting
This setting allows you to select and edit the temperature of the white colors used in
channel 6 (Macros) when in the TOUR mode.
1. Go to the CAL main level.
2. Enter the master access password as described in Control Panel Lock
3. Go to CAL1.
4. Select a white color (WH.01~11).
5. Select a color (RED, GREN, BLUE, or WHIT).
6. Select a color value (000~255).
7. Repeat for the other colors.
White Calibration
This setting allows you to select the white color shown by the COLORado™ 1 Quad IP
when the color setting is RGB.W and the DMX controller’s Red, Green, and Blue faders
are set to “255.”
1. Go to the CAL main level.
2. Enter the master access password as described in Control Panel Lock
3. Go to CAL2.
4. Select a color (RED, GREN, or BLUE).
5. Select a color value (000~255).
6. Repeat for the other colors.
When selecting CAL > CAL2 > RGB.W, you will only be able to define the values of
RED, GREN (green), and BLUE.
The values of RED, GREN (green), and BLUE configured from CAL > CAL2 > RGB.W
will define the color temperature shown when the RGB faders are set to “255” if
SET > COLO > RGB.W is active.