User manual

RUNNING IN AUTO-MODE
Action 
1) Press and hold the AUTO DEL button until
the AUTO TRIGGER LED turns on.
2) Change BANK programs by using BANK
UP/DOWN buttons if necessary.
3) You can adjust the time between steps by
moving the SPEED fader and the fade time
of the step by moving the FADE TIME
fader.
4) You can change Banks while in operation
by using the BANK UP/DOWN buttons.
Notes

In the Auto mode, programs will be triggered by
controllers fade and speed time as set on the faders.
All scenes in a Bank will chase.
CAUTION! The fade setting should never be slower
than the speed setting or the scene will never
complete execution.
To revert to the programmed speed and fade time, tap
the program button
BLACKOUT
The Blackout button brings all lighting output to 0 or off (also called the home position of the unit).
Playback (Chases)
MANUAL RUN CHASES
This function allows the user to manually step through each individual step in a chase.
Action 
1) Press and hold PROGRAM button for 3
seconds to enter programming mode.
2) Start a chase by pressing any one of the
CHASE buttons.
3) Press the TAPSYNC/DISPLAY button to
manually step through the chase.
4) Use the BANK buttons to scroll through the
chases.
5) Press and hold the PROGRAM button for 3
seconds to exit programming mode.
Notes

AUTO RUN CHASES
Action 
1) Press any one of the CHASE buttons.
2) Press and release the Auto / Del button.
The corresponding LED will blink.
3) Adjust the SPEED and FADE TIME faders
to your liking.
4) You can override the speed and fade time
by tapping the TAPSYNC/DISPLAY button
(three) times. The chase will now run on the
interval time of the taps.
Notes

CAUTION! The fade setting should never be slower
than the speed setting or the scene will never
complete execution.
DMX-70 User Manual 16 Revised: 2008-02-21 13:02:14