User manual

DMX-4 User Manual 5
Figure 1 - Hanging Clamp
Note!
Clamp is sold separately.
SETUP
Power
Your product is capable of operating on AC 100-240V. But, please be aware that your output voltage
equals your input voltage. This means that if you have the DMX-4 plugged into 120V of power, then
you will be sending 120V output to any fixture that you plug into one of the 8 outlets. Likewise, if you
have the fixture plugged into 208v, then you will get 208V out from the 8 outlets.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture’s specifications chart.
A fixture’s listed current rating is its average current draw under normal conditions.
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100%
switch.
Before applying power to a fixture, check that the source voltage matches the fixture’s requirement.
All fixtures must be connected to circuits with a suitable Earth Ground.
Mounting
ORIENTATION
This fixture may be mounted in any safe position provided there is adequate room for ventilation.
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
Safety cables should always be used.
Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.