User manual

ManualsBrandsChauvet ManualsProjectorsDMX-DFI 2.0

Snapshot

Ok on Dimmer

Outdoor OK

Sound Activated

DMX512

Master/Slave

115V/230V Switch

Replaceable Fuse

User Serviceable

Duty Cycle

DMX-DFI 2.0 User Manual

CHAUVET, 3000 N 29

Ct, Hollywood, FL 33020 U.S.A.

(800) 762-1084 – (954) 929-1115

FAX (954) 929-5560

www.chauvetlighting.com

1. BEFORE YOU BEGIN

Unpacking Instructions

Immediately upon receiving a product, carefully unpack the carton, check the contents to ensure that

all parts are present, and have been received in good condition. Notify the shipper immediately and

retain packing material for inspection if any parts appear damaged from shipping or the carton itself

shows signs of mishandling.

Save the carton and all packing materials. In the event that a fixture

must be returned to the factor

y, it is important that the fixture be returned in the original factory box

and packing.

Your shipment includes the following:

¾ 1 x D-Fi™ 2.0

¾ 1 x Power adapter

¾ 1

x Warranty Card

¾ 1 x Users Manual

Important Safety Information

Caution! There are no user serviceable parts inside the unit. Do not open the housing or attempt

any repairs yourself. In the unlikely event your unit may require service, please contact

CHAUVET.

Caution! Changes or mo

difications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

Caution! This

unit can

only be used for point-to-point operation. Point-to-multipoint systems, omni-

directional applications and multi co-located intentional radiators transmitting the same

information are not allowed.

Summary of content (5 pages)

PAGE 1
Snapshot Ok on Dimmer Outdoor OK Sound Activated DMX512 DMX-DFI 2.0 User Manual Master/Slave 115V/230V Switch Replaceable Fuse User Serviceable Duty Cycle 1. BEFORE YOU BEGIN Unpacking Instructions Immediately upon receiving a product, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition.
PAGE 2
. INTRODUCTION Product Overview Frequency indicator lights Mode indicator lights Antenna Power input connector (12V DC) Keyhole slots for wall mounting DMX input connector Dipswitch settings for transmit, receive, and channel select DMX output connector Note: Picture is for illustrative purposes only. Units are sold individually. (1 unit per package) 3. SETUP AC Power Warning! Verify that the voltage requirement label on your power adapter matches the line voltage applied.
PAGE 3
Dipswitch Chart DIPSWITCHES FUNCTION 1 2 3 4 Off Off Off Off Transmitting on 909 MHz Off Off Off On Transmitting on 910 MHz Off Off On Off Transmitting on 915 MHz Off Off On On Transmitting on 925 MHz Off On Off Off Reserved Off On Off On Reserved Off On On Off Transmitting on 916 MHz Off On On On Transmitting on 926 MHz On Off Off Off Receiving on 909 MHz On Off Off On Receiving on 910 MHz On Off On Off Receiving on 915 MHz On Off On On Recei
PAGE 4
. OPERATING INSTRUCTIONS Any number of D-Fi TM D-Fi 2.0 system. Note: TM 2.0 units can be used together in a given venue. These instructions will explain how to properly set up a TM Since D-Fi 2.0 units can operate on six separate frequencies, it is possible to have six D-Fi TM 2.0 systems operating independently of each other in one venue. This means that up to six universes may be run wirelessly in one venue using the D-Fi™2.0.
PAGE 5
. APPENDIX Returns Procedure Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued. Package must be clearly labeled with a Return Merchandise Authorization Number (RMA #). Products returned without an RMA # will be refused. Call CHAUVET and request an RMA # prior to shipping the fixture. Be prepared to provide the model number, serial number and a brief description of the cause for the return.