User Manual
TABLE OF CONTENTS 1. BEFORE YOU BEGIN............................................................................................................................................................ 3 WHAT IS INCLUDED ...................................................................................................................................................................... 3 UNPACKING INSTRUCTIONS ..........................................................................................................
1. BEFORE YOU BEGIN What is Included • • • • 1 x Gobo Zoom™ LED 2.0 1 x Set of 4 Colored Gels 1 x Set of 8 Replacement Gobos 1 x FREE CHAVUET® Logo Gobo • • • • Hanging Bracket with Mounting Hardware 1 x Power Cord 1 x Warranty Card 1 x Quick Reference Guide Unpacking Instructions Immediately upon receiving a product, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition.
Safety Notes Please read these instructions carefully. It includes important information about the installation, usage and maintenance of this product. • • • • • • • • • • • • • • Page 4 of 12 Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.
2. INTRODUCTION Product Overview Mounting Bracket DMX Out DIP Switches DMX In Safety Bracket Adjustment Knob Bracket Adjustment Knob Power In Fuseholder Zoom Thumbscrew Adjustment Focus Thumbscrew Adjustment Gobo Holder Gobo Zoom™ LED 2.0 Rev.
3. SETUP AC Power This product runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line voltage to which you are connecting it is within the range of accepted voltages. To determine the power requirements for a particular product, see the label affixed to the back plate of the product or refer to the product’s specifications chart. A product’s listed current rating indicates its average current draw under normal conditions. Always connect the product to a switched circuit.
Mounting Orientation The Gobo Zoom™ LED 2.0 may be mounted in any position, provided there is adequate room for ventilation. Rigging Be sure that the structure can support the weight of the product. Please see the “Technical Specifications” section of this manual for a detailed weight listing. Mount the product securely. This may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13 mm in size. When rigging consider routine maintenance and control panel access.
4. OPERATING INSTRUCTIONS Configuring the Starting Address The Gobo Zoom™ LED 2.0 product uses two DMX channels. The highest channel that the product may be set to in order to function properly is 511. Any address higher than this will prevent access to all of the channels. If this is your first time using DMX, we recommend reading the “DMX Primer” section in the “Appendix”. DMX Operation This is the operating mode which will allow for control with an external DMX controller.
5. APPENDIX General Troubleshooting SYMPTOM Breaker/Fuse keeps blowing Device does not power up POSSIBLE CAUSE(S) • Excessive circuit load • Check total load placed on the electrical circuit. • Short circuit along the power wires • Check for a short in the electrical wiring (internal and/or external). • No power • Loose power cord • Check for power on Mains.
Always dry the parts carefully after cleaning them. Never spin a fan using compressed air. Returns Returned merchandise must be sent prepaid and in the original packing; call tags will not be issued. Package must be clearly labeled with a Return Merchandize Authorization Number (RMA #). Products returned without the RMA # will be refused. Call CHAUVET® and request an RMA # prior to shipping the product.
TECHNICAL SPECIFICATIONS WEIGHT & DIMENSIONS Length .......................................................................................................................................................................9 in (230 mm) Width ......................................................................................................................................................................7.3 in (185 mm) Height.....................................................................................
Contact Us World Headquarters United Kingdom & Ireland CHAUVET® CHAUVET® Europe Ltd. General Information Address: 5200 NW 108th Avenue Sunrise, FL 33351 Voice: (954) 577-4455 Fax: (954) 929-5560 Toll free: (800) 762-1084 Technical Support Voice: (954) 577-4455 (Press 4) Fax: (954) 756-8015 Email: tech@chauvetlighting.com General Information Address: Unit 1C Brookhill Road Industrial Estate Pinxton, Nottingham, UK NG16 6NT Voice: +44 (0)1773 511115 Fax: +44 (0)1773 511110 Email: uktech@chauvetlighting.
