User manual

Page 6 of 12 Gobo Zoom LED 2.0 (Rev. 4)
3. SETUP
AC Power
This product runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure
the line voltage to which you are connecting it is within the range of accepted voltages.
To determine the power requirements for a particular product, see the label affixed to the
back plate of the product or refer to the product’s specifications chart. A product’s listed
current rating indicates its average current draw under normal conditions.
Always connect the product to a switched circuit. Never connect the product to a
rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used only as a 0 to 100% switch.
Always connect the product to a circuit with a suitable electrical ground.
Replacing the Gobo/Color Gel
This product has replaceable gobos and colored gels. See the instructions below.
1. Remove power to the Gobo Zoom™ LED 2.0.
2. On the underside of the product, locate the two thumbscrews that secure the
gobo holder in place.
3. Remove the thumbscrews and carefully slide the gobo holder vertically apart
from the product.
4. Locate the gobo retainer ring and remove it. Use caution for this step, as the
retainer ring will be under tension. This may cause the ring to be difficult to
remove, as well as unstable after removal. Be careful not to lose it.
5. Remove any gobo that may already be installed.
6. Place the new color gel and gobo in position in the gobo holder, shown below.
7. Reinstall the gobo retainer ring securely.
8. Slide the gobo holder back into the product and tighten the two thumbscrews.
NOTE: To make your own gobos, buy any transparency from an office supply store that is less than
1 mm thick. See www.chauvetlighting.com
for more information. Rotating gobo size: 28.6 mm
outside, 26 mm image.
Gobo Holder
Thumbscrews
Gobo
Retainer Ring
Gobo
Color Gel