User manual

Page 8 of 12 Gobo Zoom LED 2.0 (Rev. 4)
4. OPERATING INSTRUCTIONS
Configuring the Starting Address
The Gobo Zoom™ LED 2.0 product uses two DMX channels. The highest channel that
the product may be set to in order to function properly is 511. Any address higher than this
will prevent access to all of the channels.
If this is your first time using DMX, we recommend reading the “DMX Primer” section in
the “Appendix”.
DMX Operation
This is the operating mode which will allow for control with an external DMX controller.
You must set the starting address for this mode. If this is your first time using DMX, then it
is recommended that you refer to the “DMX Primer” section in the “Appendix” of this
manual.
Mode DIP switches
DMX 1~9 = set to the DMX starting address
10 = On (DMX mode)
Standalone
This product has preprogrammed operating modes. These are accessed via the DIP
switches on the back of the product.
DIP switch [10] must be OFF in this mode.
Please see the chart below for further explanation.
Mode
100% Dimmer, Slow Rotation Speed
100% Dimmer, Medium Rotation
Speed
100% Dimmer, Fast Rotation Speed
100% Dimmer, No Rotation
DIP switches
1 = ON
2 = ON
3 = ON
4 = ON
The DIP switches will not work together. Higher the switch values have higher priority. Only
use one out of the four modes listed above!
DMX Channel Values
CHANNEL
VALUE
FUNCTION
1
000 ó 255
Dimmer
0%~100%
2
000
ó
255
Gobo Rotation
Slow~fast
The product ships with the gobos shown below.