User manual

Page 14 of 19 HIVE™ User Manual
Configuration
(Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
• Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode (either Static,
Auto, or Sound-Active) to a DMX string connected to a DMX controller. Products
in standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
Auto Program
including
Sound-Active
Mode
To enable the auto (Sound-Active) program, follow the instructions below:
1. Press <MENU> to reach the menu’s main level and Addr shows on the display.
2. Use <UP> or <DOWN> until AUto shows on the display.
3. Press <ENTER> and rUn shows on the display.
4. Press <ENTER>.
NOTE: While in Auto Program mode, the HIVE™ will respond to sound.
The product will only respond to low frequencies of music (bass and drums).