User manual

Page 8 of 16 Hurricane™ Haze 3D User Manual Rev. 1
Mounting
Orientation
The Hurricane™ Haze 3D may not be tilted.
This product should be mounted,
placed on the ground, or on any oblique surface at a less than 15° angle to avoid
the risk of the haze fluid tank leaking. Be sure
there is adequate room for
ventilation and programming.
Rigging
Be sure that the structure or surface onto which you are mounting this product can
support its weight. Please see the Technical Specifications
section of this manual
for weight information.
Make sure to mount the product securely
to a rigging point, whether an elevated
platform or a truss.
When rigging this product onto a truss, you should use a mounting clamp of
appropriate weight capacity. The bracket has a 13 mm hole, which is appropriate
for this purpose.
When mounting this product overhead, always use a safety cable. Never mount
directly above people as condensation may drip and fluid may be hot.
Before deciding on a location for this product, always make sure that it will be easy
to access the unit for maintenance and programming purposes.
When power linking multiple products, you must always consider the length of the
power linking cable and mount the products close enough for the cable to reach
them.
Only loosen or tighten the bracket knobs using your bare hands. Using tools could
damage the knobs.