User manual

Operating Instructions
ILS-CON User Manual 12 3/28/2005 3:03:00 PM
12 Programmed movement effects
1 2 3 4 5 6 7 8 9 10 11 12
APPLY MOVEMENT EFFECT TO A SCENE
There are 12 preset Pan/Tilt movement programs available for you to choose while programming
intelligent lights. These are also called effects. You can apply a different movement effect to every
step in a chase if you so desire.
Action 
1) Enter program editor (mode)
2) Select Scanners button and select
fixture(s) (Buttons 1~24).
3) Press the Movement trait.
Notes 
You can choose multiple fixtures. To deselect fixtures
just press the button twice. Tap the Scanners button
to toggle between fixtures 1~12 and 13~24 as
indicated by the top LED and bottom LED
respectively. This is called changing pages. You will
notice that not all trait buttons have 2 pages, so
therefore only buttons 1 ~ 12 are available.
Tip! Quickly open the shutter on the light by pressing
Shutter and Button #2. Then return to Movement.
4) Select any of the 12 movement effects
available by pressing any one of the
Buttons (1~12).
5) Press the Save button.
6) Select Buttons (1~24) to store into
memory.
To disable effects or to return control to the joystick
tap Movement again.
The buttons section will now turn into memory
locations 1 ~ 24 for playback.
Shortcut: Tap [Blackout] until LED turns OFF  Select [Scanner]  Select [Button(s)] (fixtures) 
Select [Movement]  Select [Buttons 1~12]  Select other [traits] & modify  Press [Save] 
Select [Button 1~24] to store to memory
PREVIEWING MEMORY (SCENE OR CHASE)
While in the program editor, you can preview a scene or chase. A chase consists of one or more
scenes. Every scene within a chase is considered a step. We will use the term scene and step
interchangeably through out this manual.
Action 
1) Press the Memory button.
2) Select the scene or chase you previously
stored represented by Buttons (1~24).
3) If previewing a chase, simply press the
same memory button again to preview
another existing step in the chase.
Notes 
Remember! The Page button toggles between Page 1
and Page 2 giving you access to memory locations 13
~ 24.
There is no way of traversing backwards so if you
pass a step you wanted to edit you will need to either
continue forward until it loops back again or select
another memory button and then return to the one
desire.
Shortcut: Press [Memory]  Select [Button 1~24] (program)  Select same button to preview
another step  Select other [Button 1~24] to preview another scene or chase