User manual

Page 12 of 17 Intimidator Scan™ LED 300 User Manual Rev. 6
Configuration
(Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
Never connect a product that is operating in any standalone mode (either Static,
Automatic, or Sound) to a DMX string connected to a DMX controller. Product
s in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
Sound-Active
Mode
To enable the Sound-Active mode:
1. Press <MODE/ESC> repeatedly until one of the Standalone modes shows on the
display (SLAu, NStS, NAFA, NASL).
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select <NStS>.
4. Press <ENTER>. <SrUn> will appear on the display.
The product will only respond to low frequencies of music (bass and drums).
Auto Program
To enable the Auto program:
1. Press <MODE/ESC> repeatedly until one of the Standalone modes shows on the
display (SLAu, NStS, NAFA, NASL).
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select <NAFA>.
4. Press <ENTER>. <FASt> will appear on the display.