User manual

Intimidator™ Wave IRC User Manual Rev. 1 Page 13 of 32
Master Auto
2-
Head
Program
The Master Auto 2-Head program allows a single Intimidator™ Wave IRC
to control the actions
of another Intimidator™ Wave IRC. The master unit will be set to operate in the M-
2 program,
while the slave unit will be set to operate in either Slave S-1 or Slave S-2 mode.
Configure the units as indicated below.
Master unit:
1. Press <MENU> and use <UP> or <DOWN> to select Setup.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Mast Set and press <ENTER>.
4. Use <UP> or <DOWN> to scroll to M-1, M-2, or M-4.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select M-2.
7. Press <ENTER>.
Slave unit:
1. Press <MENU> and use <UP> or <DOWN> to select Run Mode.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Slave S-1, or Slave S-2.
• Select Slave S-1 for 100% synchronized actions with both units,
up to 10 heads in
tandem.
• Select Slave S-2 for a delayed wave, up to 10 heads.
4. Press <ENTER>.
Master Auto
1-
Head
Program
The Master Auto 1-Head program allows all 4 heads of two linked Intimidator™ Wave IRC
units
to operate in unison. The master unit will be set to operate in the
M-1 program, while the slave unit will be set to operate in Slave S-1, Slave S-2, Slave S-
3, or
Slave S-4 mode.
Configure the units as indicated below.
Master unit:
1. Press <MENU> and use <UP> or <DOWN> to select Setup.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Mast Set and press <ENTER>.
4. Use <UP> or <DOWN> to scroll to M-1, M-2, or M-4.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select M-1.
7. Press <ENTER>.
Slave unit:
1. Press <MENU> and use <UP> or <DOWN> to select Run Mode.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Slave S-1, Slave S-2, Slave S-3, or Slave S-4.
4. Press <ENTER>.
5. Select Slave S-1 for 100% synchronized control of up to another 20 heads.
6. Press <ENTER>.