User manual

Page 28 of 32 Intimidator™ Wave IRC User Manual Rev. 1
Display Blackout
and Reverse
You can flip the LED display for easy readability in any mounting situation
or blackout
the display entirely.
To select your display angle:
1. Press <MENU> and use the <UP> or <DOWN> buttons to select Setup.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Screen Reverse and press <ENTER>.
4. Use <UP> or <DOWN> to select ON or OFF and press <ENTER>.
To select blackout display:
1. Press <MENU> and use the <UP> or <DOWN> buttons to select Setup.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Display and press <ENTER>.
4. Use <UP> or <DOWN> to select ON or OFF and press <ENTER>.
Master/Slave
Mode
The Master/Slave mode allows a single Intimidator™ Wave IRC
unit (the master) to
control the actions of one or more Intimidator™ Wave IRC
units (the slaves) without a
DMX controller. The master unit operates in either Automatic or Sound-
Active mode,
while the slave units operate in Slave m
ode. Once set and connected, the slave units
will operate in unison with the master unit.
Configure the units as described below.
Slave units:
1. Press <MENU> and use <UP> or <DOWN> to select Run Mode.
2. Press <ENTER>.
3. Press <UP> or <DOWN> to select Slave S-1.
4. Press <ENTER>.
5. Set the DMX address to 001.
6. Connect the DMX input of the first slave unit to the DMX output of the master unit.
7. Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
8. Finish setting and connecting all the slave units.
Master unit:
1. Set the master unit to operate in either Automatic or Sound-Active mode.
2. Make the master unit the first unit in the DMX daisy chain.
• Configure
all the slave units before connecting the master unit to the DMX
daisy chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the
signals from the
master unit.
• Do not connect more than 4 slave units to the master unit.
Reset
Software
To reset the software on the Intimidator™ Wave IRC, do the following:
1. Press <MENU> and use the <UP> or <DOWN> buttons to select Setup.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Reset.
4. Press <ENTER>. The product will reset all settings in the software.
Factory
Defaults
To load the factory defaults on the Intimidator™ Wave IRC, do the following:
1. Press <MENU> and use the <UP> or <DOWN> buttons to select Setup.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Factory Reset.
4. Press <ENTER>. The product resets to factory default settings.